Woods Equipment S30CD manual Without Quick Hitch Attachment, Removing Shredder from Tractor

Without Quick Hitch Attachment:

10.Back tractor lower 3-point arms between lower mast plates and align with lower 3-point hole.

11.Place 1-3/4 OD spacer through 3-point arm pivot (both sides).

12.Push tractor’s 3-point arm to the inside and slide a 1-7/16 OD spacer between to take up the empty space. Secure with lower 3-point hitch pin assembly, 1-3/4 OD spacer, and 7/16 x 2 klik pin.

13.Repeat steps 5 and 6 for other side.

14.Lower the tractor’s top link arm and secure in top hole of upper mast assembly using spacer, hex bolt, and lock nut. Attach PTO Driveline

1.Make sure the driveline telescopes easily and shields rotate freely.

2.Attach the driveline to the tractor by retracting the locking collar. Slide the yoke over the shaft and push on the yoke until the lock collar clicks into position. Make sure the yoke is locked into position.

Attach Hydraulics and Lift Cylinder Hose (Center Cutter Option)

1.Use a clean cloth to clean hose ends and area around the couplers on the tractor.

2.Insert the hose male ends into the tractor couplers. Make sure hoses lock in place.

3.Route hoses along or over the hitch and secure in position with clips, tape, or plastic ties. Provide enough slack for turning and lifting.

REMOVING SHREDDER FROM TRACTOR

Reverse the above procedure when removing unit from the tractor. Engage transport lock channel at the four struts prior to lowering shredder. Release pressure before removing hoses.

DP101

Figure 6. Transport Lock

FIELD OPERATION

The Woods Flail Shredder is designed with the flexibil- ity to operate well in almost any kind of crop and terrain conditions. However, the operator is responsible for being familiar with all operating and safety procedures and following them. Each operator should review this Field Operation section at the start of the season and as often as required to be familiar with the unit.

Operators should also review the PRE-OPERATION CHECK LIST, page 15, and Attaching Shredder to Tractor, page 17.

„Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319- 6637.) Failure to follow instructions or safety rules can result in serious injury or death.

„Never allow children or untrained persons to operate equipment.

„Make sure shields and guards are properly installed and in good condition. Replace if damaged.

„Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Never allow riders on power unit or attachment.

„Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.

„Inspect and clear area of stones, branches, or other hard objects that might be thrown, causing injury or damage.

„Operators must be instructed in and be capable of the safe operation of the equipment, its attach- ments, and all controls. Do not allow anyone to operate this equipment without proper instructions.

„Keep bystanders away from equipment.

„Operate tractor PTO at the rpm speed stated in “Specifications” section.

18 Operation MAN0943 (07/12/2011)