
DCA-70SSJU SERIES — GENERATOR SHUT-DOWN PROCEDURE
Shutdown Procedure - Ignition Switch (Up to S/N 73002140)
To shutdown the generator use the following procedure:
1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 45 to the "OFF“ position.
2.Place the engine throttle control in the “LOW” position (Figure 71).
Shutdown Procedure - Engine Controller (S/N 73002141~)
To shutdown the generator use the following procedure:
1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 45 to the "OFF“ position.
2.Place the engine speed switch in the “LOW” position (Figure 73).
Figure 71. Engine Throttle Control (Low)
3.Let the engine cool by running it for
4.Turn the Ignition Key Switch (Figure 72) to the “OFF“ position.
Figure 73. Engine Speed Switch (Low)
3.Let the engine cool by running it for
4.Place the
Figure 72. Engine Ignition Switch (Stop) | Figure 74. Off/Manual Auto Switch (Off) |
|
5. Remove all loads from the generator.
Emergency Shutdown Procedure - Ignition Switch (Up to S/N 73002140)
1.To
2.Turn the ignition switch key to the “STOP” position (Figure 72).
5.Verify that the all status LED on the MPEC display (Figure 68) are "OFF" (not lit).
6.Remove all loads from the generator.
Emergency Shutdown Procedure - Engine Controller (S/N 73002141~)
1.To
2.Place the
CAUTION:
NEVER stop the engine suddenly except in an emergency. DO NOT use the emergency stop switch a as method of shutting down the generator.This switch is ONLY to be used in the event of an emergency.
PAGE 46 —