DCA-500SSK — GENERATOR START-UP PROCEDURE (MANUAL)
10.The generator's voltage meter (Figure 41) displays the 120 VAC in VOLTS. If the voltage is not within the specified frequency tolerance, use the voltage adjustment control knob (Figure 42) to increase or decrease the desired voltage.
12.The engine oil pressure gauge (Figure 44) will indicate the oil pressure (kg/ cm2) of the engine. Under normal operating conditions the oil pressure should be approximately 25 psi.
Figure 41. Voltage Meter (Volts)
Figure 42. Voltage Adjust Control
Knob
11.The ammeter (Figure 43) will indicate zero amps with no load applied. When a load is applied, this meter will indicate the amount of current that the load is drawing from the generator’s alternator.
40
2060
0 | 75 |
A
Figure 44. Oil Pressure Gauge
13.The coolant temperature gauge (Figure 45) will indicate the coolant temperature. Under normal operating conditions the coolant temperature should be between 165 and 215 degrees Fahrenheit (Green Zone).
WATER TEMP