DCA-500SSK — OUTPUTTERMINAL
Voltage Change-over Board
The voltage change-over board changes the available voltages of the output terminal panel UVWO lugs. The voltage change-over board is located on the control box behind the control panel. There are six (6) plates that can be set into two set positions to get six different voltages. Unless specified differently, the generator comes from the factory in the 240V position.
240 Volt Set position
The voltage change-over board 240V set position uses all 6 plates in 6 different connection places. See figure 19 below.
Single Phase, 240 Volt
The following connection, with the voltage change-over board set into the 240V set position (See Figure 19), can offer SINGLE PHASE power at 240V. After hooking up the hard wires to the lugs as shown in figure 21 below, 240V will be the voltage output.
FIGURE 21. Hard Wire Hookup for Single Phase 240V
FIGURE 19. Voltage Change-over Board 240V set position.
3 Phase, 240 Volt
The following connection, with the voltage change-over board set into the 240V set position (See Figure 19), can offer THREE PHASE power at 240V. After hooking up the hard wires to the lugs as shown in figure 20 below, 240V will be the voltage output.
Single Phase, 139 Volt
The following connection, with the voltage change-over board set into the 240V set position (See Figure 19), can offer SINGLE PHASE power at 139V. After hooking up the hard wires to the lugs as shown in figure 22 below, 139V will be the voltage output.
FIGURE 20. Hard Wire Hookup for Three Phase 240V | FIGURE 22. Hard Wire Hookup for Single Phase 139V |
PAGE 40 — DCA-500SSK — PARTS AND OPERATION MANUAL (STD) — REV. #1 (04/14/01)
