Great Dane GSRKA1934S Mounting and Dismounting Machine Safely, Raising and Lowering Thigh Pad

OPERATING

A-Free-Wheeling Valves

CAUTION: Avoid injury! Before adjusting cut-

Mounting and Dismounting Machine Safely	ting height, stop engine and lock the park
	brake.
	1. Check tire pressure. Inflate front caster wheels to 172-
	207 CPA (25-30 psi). Inflate rear tires to 69-83 CPA
	(10-12 psi).
	CAUTION: Avoid injury! Machine must be
	safely supported on jack stands before remov-
	ing or installing wheels. Do not use a hoist or
	floor jack to support the machine.
	2. Using a suitable lifting device, lift the rear of the ma-
	chine.
A
1. Step on operator’s platform (A) at the rear of machine
to mount the machine.	B
2. Park machine safely. (See Parking Safely in the
SAFETY section.)
3. Step off operator’s platform to dismount machine.
4. Keep operator’s platform and suspension springs clean
and free of debris.	C	A
Raising and Lowering Thigh Pad
1. Park machine safely. (See Parking Safely in the	3. Loosen bolts (A).
SAFETY section.)
	4. Loosen and remove bolts (B).
	5. Move deck (C) up or down to desired height and tighten
	bolts (A) to 47-54 N•m (35-40 lb-ft).
	6. Insert bolts (B) into holes and tighten to 95-108 N•m
A	(70-80 lb-ft).
	7. Remove lynch pin (D) and spacer bushing (E).
		D
		Caster Mounting
		E In Upper Position
		F
	G
	H
2. Adjust the pad (A) as required by lifting or lowering the
pad to where it is comfortable.
Adjusting Cutting Height

Cutting height can be adjusted from approximately 38-114

MM.(1-1/2 - 4-1/2 in.). Each hole adjusts the height of cut (HOC) in 12 MM. (1/2 in.) increments.

OPERATING - 10