Black & Decker LLP120B manual Preparing AlLigator Lopper For Use, Chain tension adjustment

Page 10

Installing / Removing Battery Pack WARNING: Make certain the lock-off button is engaged to

prevent switch actuation before removing or installing battery.

replaced. Contact your nearest service center.

The product comes ready assembled. However we recommend that you check the tension of the chain, and chain retention bolts before use and if required adjust.

To install battery pack: Insert battery pack into tool until an audible click is heard (figure C).

To remove battery pack: Depress the battery release button in the back of the battery pack and pull battery pack out of tool.

C

Checking and adjusting the chain tension (figs. D, E)

To tension the chain slacken the

D

 

two chain cover retention bolts

12

(11) with the wrench (12) and the

13 11

atuomatic chain tensioning device

 

(fig E) will push the chain bar

 

 

out, setting the correct tension.

 

 

Retighten the two retention bolts

 

 

(11) securely.

 

 

Check that the correct tension has

 

 

been set by lightly pulling on the

 

 

chain. The tension is correct when

 

 

the chain snaps back after being

 

 

pulled 1/8 inch (3 mm) away from

E

 

the guide bar. There should be no

 

Preparing AlLigator Lopper For Use

WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury

WARNING: Sharp moving blade. To prevent accidental operation, ensure that the battery is disconnected from the tool before performing the following operations. Failure to do this could result in serious personal injury.

CAUTION: Sharp moving blade. Always wear protective gloves when installing or removing the chain. The chain is sharp and can cut you when it is not running.

Chain tension adjustment

WARNING: Before chain or other adjustments, make sure that the battery is disconnected from the tool.

If the chain cannot be correctly tensioned, it may need to be

“sag” between the guide bar and

chain on the underside.

Note: Do not over tension the chain

as this will lead to excessive wear

and reduce the life of the bar and

chain. It will also lead to reduced

product performance.

Note: With first use and when the chain is new, check tension

frequently as a new chain stretches slightly.

Replacing the chain and chain bar

After prolonged use the chain and / or chain bar may need replacing. Use Black+Decker replacement chain RC600 only. Low-Kickback saw chain is a chain which has met the kickback performance requirements of ANSI B175.1 when tested on the representative sample of chain saws.

10

Image 10
Contents 20v max* lithium alligator lopper Safety Instructions and Warnings for Chain Saws Important Safety InstructionsIntended use Stay Alert Disconnect BatteryMaintain Chain Saw With Care Check Damaged Parts Guard Against KickbackKickback Safety Features Additional safety instructions for AlligatorTM LopperPower Supply Electrical safety SymbolsDust, which may cause serious and permanent respiratory or Important safety instructions for Battery chargers Chain SAW Names and TermsComponents Ampere RatingImportant safety warnings For battery packs Storage RecommendationsLeaving the battery in the charger Charging ProcedureImportant Charging Notes Preparing AlLigator Lopper For Use Chain tension adjustmentReplacing the chain and chain bar Assembling the chain bar and chain figs. G, H That the battery is disconnected from the toolRemoving the saw chain & chain bar figs. F, G OperationTrimming branches Switching on fig. KOiling fig Remove branches as shown in Fig LMaintenance Replacement chain catalog number RC600 AccessoriesService Information Rbrc SealProblem Possible Cause TroubleshootingTo shutoff abruptly when the charge is depleted Two -year LImited warranty Manuel D’ Instructions Directives DE Première Importance Utilisation prÉvueScies à chaîne Entretien soigné de la scie à chaîne Porter des lunettes de sécuritéTransport de la scie à chaîne Débrancher le bloc-pilesBloc d’alimentation Directives de sÉcuritÉ concernant l’effet de rebond Sécurité en matière d’électricitéSymboles Terminologie ET Nomenclature Relatives À ’ÉBRANCHEUR’il est orienté en position verticale ou au plancher Que ceux qui sont mentionnés dans le présent mode d’emploiLe chargeur fourni avec ce produit est correctement branché Ces chargeurs n’ont pas été conçus pour être utilisés àComposantes Intensité aDirectives de sÉcuritÉ importantes pour Les blocs-piles Conserver ces mesuresLire toutes les directives Chargeur Figure B Recommandations en matière de rangementProcédure de charge Remarques importantes pour le chargementInsertion et retrait du bloc-piles de l’outil Réglage de la tension de la chaîneFig. G & H Remplacement de la chaîne et du guide-chaîne EnTretien Lubrification figFonctionnemenT Mise en marche et arrêt fig. JNettoyage Mise en marche fig. KTaillage des branches LubrificationRangement Le sceau Srprcmc AccessoiresBlack+Decker Information sur les réparations Garantie limitéE de deux ans DEpannage Problème Cause possible Solution possibleMaximiser la durée de vie du Page Podadora Alligator CON Batería DE Litio DE 20 V MÁX Uso previsto Normas generales de seguridadConserve la sierra de cadena adecuadamente Use lentes de seguridadTransporte de la sierra Desconecte la bateríaFuente de energía CaracterÍsticas de seguridad durante el Retroceso Nombres Y Términos DE LAS Sierras DE Cadena SímbolosNo exponga el cargador a la lluvia ni a la nieve Componentes AmperajeLea todas las instrucciones Nunca intente conectar 2 cargadores juntosProcedimiento de carga Notas importantes sobre la cargaAjuste de tensión de la cadena Verificación y ajuste de la tensión de la cadena Figura DRetiro de la cadena y de la barra de la sierra Figuras F y G OperaciÓn Lubricación FiguraMantenimiento Encendido KRecorte de ramas LimpiezaAfilado de la cadena de la sierra LubricaciónTransporte AlmacenamientoInformación de mantenimiento AccesoriosEl sello Rbrc Garantía limitado de dos años Problema Causa posible Solución posible Maximizar la vida útil delFerre Pat de Puebla, S.A. de C.V De Occidente, S.A. de C.V Perfiles y Herramientas de MoreliaGpo. Comercial de Htas. y Refacciones Enrique Robles

LLP120B specifications

The Black & Decker LLP120B is a versatile and powerful cordless lithium-ion electric wine opener that has gained popularity among wine enthusiasts for its sleek design and remarkable performance. This innovative tool streamlines the wine-opening process, making it an essential accessory for any home bar or kitchen.

One of the standout features of the LLP120B is its cordless convenience. This electric wine opener allows users to uncork wine bottles effortlessly without the hassle of tangled cords. Powered by a lithium-ion battery, it offers the freedom to open bottles anywhere, whether at home, during a picnic, or at a gathering with friends.

In terms of design, the Black & Decker LLP120B boasts an ergonomic grip that enhances ease of use. Its lightweight and comfortable build allows for a secure hold, making it accessible for users of all ages. With its modern aesthetic and sleek lines, it also adds a touch of elegance to any tabletop setting.

The efficiency of the LLP120B is another key characteristic. It can open up to 30 bottles on a single charge, making it ideal for entertaining guests without the worry of running out of battery power. The quick and reliable operation ensures that users can enjoy their wine without unnecessary delays.

The device is equipped with a durable stainless steel and plastic construction that guarantees longevity. Its spiral and corkscrew mechanism is designed to fit all standard cork sizes, providing versatility for various wine bottles. Additionally, the LLP120B features a built-in foil cutter, allowing users to remove foil caps with ease before uncorking their bottles.

Charging the Black & Decker LLP120B is a breeze, thanks to its convenient charging base that allows the opener to be stored tidily when not in use. This aspect not only maintains the device but ensures that it is always ready for action when needed.

In conclusion, the Black & Decker LLP120B is an exceptional electric wine opener that combines convenience, efficiency, and style. Its cordless design, ergonomic grip, sturdy construction, and ability to handle multiple bottles on a single charge position it as a must-have for wine lovers. Whether hosting a casual gathering or enjoying a quiet evening, this electric wine opener makes the experience smoother and more enjoyable.