Black & Decker LLP120B manual Charging Procedure, Leaving the battery in the charger

Page 9

Charging Procedure

Black+Decker chargers are designed to charge

Black+Decker battery packs in 3.5-4 hours depending on the

pack being charged.

 

1. Plug the charger into an appropriate outlet before inserting the

battery pack.

 

2. Insert the battery pack into the

B

charger as shown in figure B.

3. The green LED will flash

 

indicating that the battery is being

 

charged.

 

4. The completion of charge

 

is indicated by the green LED

 

remaining on continuously. The

 

pack is fully charged and may

 

be used at this time or left on the

 

charger.

 

Recharge discharged batteries

 

as soon as possible after use or battery life may be greatly

diminished. It is recommended that the batteries be recharged after

each use.

 

Leaving the battery in the charger

The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 60°F and 80°F (16°- 27°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as

in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other appliance.

b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights.

c. Move charger and battery pack to a location where the surrounding air temperature is approximately 60°F and 80°F (16°- 27°C).

d. If charging problems persist, take the tool, battery pack and charger to your local service center.

4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

WARNING: Shock hazard. Do not allow any liquid to get inside charger. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 20v max* lithium alligator lopper Important Safety Instructions Safety Instructions and Warnings for Chain SawsIntended use Maintain Chain Saw With Care Disconnect BatteryStay Alert Check Damaged Parts Guard Against KickbackAdditional safety instructions for AlligatorTM Lopper Kickback Safety FeaturesPower Supply Symbols Electrical safetyDust, which may cause serious and permanent respiratory or Chain SAW Names and Terms Important safety instructions for Battery chargersAmpere Rating ComponentsStorage Recommendations Important safety warnings For battery packsCharging Procedure Leaving the battery in the chargerImportant Charging Notes Chain tension adjustment Preparing AlLigator Lopper For UseReplacing the chain and chain bar Removing the saw chain & chain bar figs. F, G That the battery is disconnected from the toolAssembling the chain bar and chain figs. G, H OperationOiling fig Switching on fig. KTrimming branches Remove branches as shown in Fig LMaintenance Service Information AccessoriesReplacement chain catalog number RC600 Rbrc SealTroubleshooting Problem Possible CauseTo shutoff abruptly when the charge is depleted Two -year LImited warranty Manuel D’ Instructions Utilisation prÉvue Directives DE Première ImportanceScies à chaîne Transport de la scie à chaîne Porter des lunettes de sécuritéEntretien soigné de la scie à chaîne Débrancher le bloc-pilesBloc d’alimentation Sécurité en matière d’électricité Directives de sÉcuritÉ concernant l’effet de rebondTerminologie ET Nomenclature Relatives À ’ÉBRANCHEUR SymbolesLe chargeur fourni avec ce produit est correctement branché Que ceux qui sont mentionnés dans le présent mode d’emploi’il est orienté en position verticale ou au plancher Ces chargeurs n’ont pas été conçus pour être utilisés àIntensité a ComposantesConserver ces mesures Directives de sÉcuritÉ importantes pour Les blocs-pilesLire toutes les directives Procédure de charge Recommandations en matière de rangementChargeur Figure B Remarques importantes pour le chargementRéglage de la tension de la chaîne Insertion et retrait du bloc-piles de l’outilFig. G & H Remplacement de la chaîne et du guide-chaîne FonctionnemenT Lubrification figEnTretien Mise en marche et arrêt fig. JTaillage des branches Mise en marche fig. KNettoyage LubrificationRangement Accessoires Le sceau SrprcmcBlack+Decker Information sur les réparations Garantie limitéE de deux ans Problème Cause possible Solution possible DEpannageMaximiser la durée de vie du Page Podadora Alligator CON Batería DE Litio DE 20 V MÁX Normas generales de seguridad Uso previstoTransporte de la sierra Use lentes de seguridadConserve la sierra de cadena adecuadamente Desconecte la bateríaFuente de energía CaracterÍsticas de seguridad durante el Retroceso Símbolos Nombres Y Términos DE LAS Sierras DE CadenaNo exponga el cargador a la lluvia ni a la nieve Amperaje ComponentesNunca intente conectar 2 cargadores juntos Lea todas las instruccionesNotas importantes sobre la carga Procedimiento de cargaVerificación y ajuste de la tensión de la cadena Figura D Ajuste de tensión de la cadenaRetiro de la cadena y de la barra de la sierra Figuras F y G Lubricación Figura OperaciÓnRecorte de ramas Encendido KMantenimiento LimpiezaTransporte LubricaciónAfilado de la cadena de la sierra AlmacenamientoAccesorios Información de mantenimientoEl sello Rbrc Garantía limitado de dos años Maximizar la vida útil del Problema Causa posible Solución posibleGpo. Comercial de Htas. y Refacciones Perfiles y Herramientas de MoreliaFerre Pat de Puebla, S.A. de C.V De Occidente, S.A. de C.V Enrique Robles

LLP120B specifications

The Black & Decker LLP120B is a versatile and powerful cordless lithium-ion electric wine opener that has gained popularity among wine enthusiasts for its sleek design and remarkable performance. This innovative tool streamlines the wine-opening process, making it an essential accessory for any home bar or kitchen.

One of the standout features of the LLP120B is its cordless convenience. This electric wine opener allows users to uncork wine bottles effortlessly without the hassle of tangled cords. Powered by a lithium-ion battery, it offers the freedom to open bottles anywhere, whether at home, during a picnic, or at a gathering with friends.

In terms of design, the Black & Decker LLP120B boasts an ergonomic grip that enhances ease of use. Its lightweight and comfortable build allows for a secure hold, making it accessible for users of all ages. With its modern aesthetic and sleek lines, it also adds a touch of elegance to any tabletop setting.

The efficiency of the LLP120B is another key characteristic. It can open up to 30 bottles on a single charge, making it ideal for entertaining guests without the worry of running out of battery power. The quick and reliable operation ensures that users can enjoy their wine without unnecessary delays.

The device is equipped with a durable stainless steel and plastic construction that guarantees longevity. Its spiral and corkscrew mechanism is designed to fit all standard cork sizes, providing versatility for various wine bottles. Additionally, the LLP120B features a built-in foil cutter, allowing users to remove foil caps with ease before uncorking their bottles.

Charging the Black & Decker LLP120B is a breeze, thanks to its convenient charging base that allows the opener to be stored tidily when not in use. This aspect not only maintains the device but ensures that it is always ready for action when needed.

In conclusion, the Black & Decker LLP120B is an exceptional electric wine opener that combines convenience, efficiency, and style. Its cordless design, ergonomic grip, sturdy construction, and ability to handle multiple bottles on a single charge position it as a must-have for wine lovers. Whether hosting a casual gathering or enjoying a quiet evening, this electric wine opener makes the experience smoother and more enjoyable.
Top Page Image Contents