Alliance Laundry Systems CHM1772C manual Operator Safety

Page 7

Operator Safety

WARNING

NEVER insert hands or objects into basket until it has completely stopped. Doing so could result in serious injury.

SW012

To ensure the safety of machine operators, the following maintenance checks must be performed daily:

1.Prior to operating the machine, verify that all warning signs are present and legible. Missing or illegible signs must be replaced immediately. Make certain that spares are available.

2.Check door interlock before starting operation of the machine:

a.Attempt to start the machine with the door open. The machine should not start with the door open.

b.Close the door and start the machine. The machine should not start with the door unlocked.

c.Attempt to open the door while the cycle is in progress. The door should not open.

If the door lock and interlock are not functioning properly, disconnect power and call a service technician.

3.Do not attempt to operate the machine if any of the following conditions are present:

a.The door does not remain securely locked during the entire cycle.

b.Excessively high water level is evident.

c.Machine is not connected to a properly grounded circuit.

Safety Information

Do not bypass any safety devices in the machine.

WARNING

Operating the machine with severe out-of- balance loads could result in personal injury and serious equipment damage.

W728

F8208301

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

5

Image 7
Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Do not bypass any safety devices in the machine Operator SafetyModel Model IdentificationIntroduction 125 PoundNameplate Location Delivery InspectionIntroduction Model Number Familiarization Guide CN040GC2OUID01Customer Service Replacement PartsWash Cylinder Information Speed Models Specification Weight and Shipping InformationCylinder Speeds Power ConsumptionEstimated Building Heat Load Drive Train InformationElectrical Heating Optional Number of motors in drive train Drive motor power, hp kW Electrical Heating Specifications and Dimensions Specifications and Dimensions Machine Capacity Dimensions 92 in 252 mm 94 in 202 mm Machine Capacity Dimensional Clearances Dimensions 125 Dimensional ClearancesMinimum Depth Methods Requirement Machine FoundationMinimum Floor Load Data, Variable-Speed Models Specification 125 Floor Load Data, 2 Speed Models Specification20, 30, 40 and 60 Models Concrete Foundation InstallationInstallation Models Ft.- lbs Direct-to-Finished-Floor InstallationAnchor Specifications Refer to Figure Machine AnchoringCompleted expansion bolt installation is shown in Figure Elevated Base Frame InstallationP035I Models Mounting Bolt Hole Locations Without Elevated Base FramesFront of Frame 19 mm 45 mm 660 mm 32 mm 41.5 1054 mm 1219 mm Mounting Bolt Hole Locations With Elevated Base Frames CHM2072N 92 mm 56 mm Drain Trough Drain ConnectionDrain Line Sizing Minimum Drain ID Model Number of Machines Drain Information 125Hot/Cold Water Connection RequirementsCabinet Hardmount Water Supply Information Number Supply Line Size MachinesElectrical Installation Requirements Input Power Condition Corrective Action Input Power ConditioningGrounding Connection SpecificationsInput Voltage Requirements Circuit Breakers and Quick DisconnectsThermal Overload Protector Phase AdderStandard Electric Heat Installation Electrical Specifications Pound Capacity Models380 440 200 208 Variable-Speed Models 380-415 440-480 200 208-240 10.0 380 50/60 10.0 Supply Dispensing Steam Requirements Steam Heat Option OnlySupply Dispensing Steam Supply InformationExternal Supplies 20 80 Pound OPL Models Connection of External Liquid SuppliesBasket Rotation Start Up
Related manuals
Manual 19 pages 8.07 Kb