ASSEMBLY
REMOVAL FROM TRACTOR
1.Select a firm level site for parking the machine.
2.Lower the parking legs and secure.
3.Operate the hydraulic service to place the arms at 1/2 to 3/4 reach and with the flail head roller horizontal and level with the bottom of the parking feet.
4.Disengage tractor PTO and remove.
5.Disconnect stabilizers bars or loosen check chains as applicable.
6.Unbolt the control unit from the mounting pillar, remove from tractor cab and stow in a suitable location clear of the ground. On Si models only, the supply and return hoses must be disconnected from the tractor and stowed with their ends covered and clear of the ground.
7.Raise the machine on the tractor’s linkage to take the weight off the yoke and remove the lower yoke bolts.
8.Lower the tractor draft links and place machine firmly on the ground.
9.Remove draft links and top link from the machine, drive tractor away and remove yoke. Blank off the end of the return hose with plug or small plastic bag if a
STORAGE
If machine is to be left standing for an extended period of time, lightly coat the exposed portions of the ram rods with grease. Subsequently, this grease which becomes contaminated with dust and grit should be wiped off before the rams are next moved.
If the machine has to be stored outside, tie a piece of tarpaulin or canvas over the control assembly. Do not use a plastic fertilizer bag which could lead to rapid corrosion.
PA91 03/09 | Assembly Section |
© 2009 Alamo Group Inc.