Alamo 7191852C manual TRACTOR, BOOM, and Attached Head Storage

Page 91

OPERATION

9.8 TRACTOR, BOOM, AND ATTACHED HEAD STORAGE

 

Properly preparing and storing the unit at the end of the season is critical to maintaining its appearance and to

 

help ensure years of dependable service. The following are suggested storage procedures:

 

• Thoroughly clean all debris from boom and

 

 

 

 

 

head to prevent damage from rotting grass and

 

 

 

standing water.

 

 

 

• Lubricate all grease points and fill oil levels

 

 

 

according to the maintenance lubrication

 

 

 

 

 

 

schedule.

 

 

OPERATION

on bare metal surfaces to prevent rust and to

 

 

• Tighten all bolts to the proper torque. Ensure

 

 

 

all pins and other hardware are in place.

 

 

 

• Check the boom arm and head for worn and

 

 

 

damaged parts. Perform repairs and make

 

 

 

replacements so that the mower will be ready

 

 

 

for use at the start of the next season.

 

 

 

• Store the unit in a clean and dry location.

 

 

 

• Use spray touch-up enamel where necessary

 

 

 

 

 

 

maintain the appearance of the mower.

 

OPS-B- 0012_E

 

 

 

 

Never allow children to play on or around Tractor or Implement. Children can slip or fall off

 

the Equipment and be injured or killed. Children can cause the Implement to shift or fall

 

crushing themselves or others. (SG-25)

 

BEFORE leaving the tractor seat, always engage the brake and/or set

 

the tractor transmission in parking gear, disengage the PTO, stop the

 

engine, remove the key, and wait for all moving parts to stop. Place the

 

tractor shift lever into a low range or parking gear to prevent the tractor

 

from rolling. Never dismount a Tractor that is moving or while the engine

 

is running. Operate the Tractor controls from the tractor seat only. (SG-9)

 

Always shut the Tractor completely down, place the transmission in park, and set the

 

parking brake before you or anyone else attempts to connect or disconnect the Implement

 

and Tractor hitches. (S3PT-15)

 

Never allow children to play on or around Tractor or Implement. Children can slip or fall off

 

the Equipment and be injured or killed. Children can cause the Implement to shift or fall

 

crushing themselves or others. (SG-25)

 

PA91 02/08

Operation Section 4-39

© 2009 Alamo Group Inc.

Image 91
Contents PA91 To the Owner/Operator/Dealer Page Alamo Industrial Division is willing to provide Table of Contents Maintenance Section Cables Hydraulic Rams Page Safety Section Safety Wait a minute...Save a life Operator Safety Instructions and PracticesSafety Equipment Operation Safety Instructions and Practices Safety Safety Safety SGM-06 Safety Stop Mowing if Passersby are Within 100 Yards Unless Transporting Safety Instructions and Practices Safety Maintenance and Service Safety Instructions and Practices Safety Concluding Safety Instructions and Practices Decal Location QTY Level Description Decal Description Safety Safety Safety PA91 03/09 Safety Section Safety Safety Alamo Industrial Logo Alamo Name Logo Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Fitting Operator Guard Tractor PreparationJohn Deere Conversion KIT 81- 30 Ballast WeightAttachment to Tractor DeliverySi Model Ti Model Assembly Fitting Control Unit in CAB Tank OIL RequirementsGearbox PA91 Ti Running UP ProcedurePA91 Si Storage Removal from TractorProper Torque Values for Fasteners Operation Section Operation Head Specifications Standard SpecificationsPersonal Protective Equipment PPE Operator RequirementsRops and Seat Belt Tractor RequirementsOperator Thrown Object Protection Tractor Lighting and SMV Emblem Tractor Horsepower Tractor Safety DevicesTractor Ballast 3-Point Hitch Front End WeightHydraulics Getting on and OFF the Tractor Power Take Off PTODismounting the Tractor Boarding the TractorStarting the Tractor Connecting Mower Head Hydraulics Connecting Attaching Head to the BoomPA91 02/08 Operation Section Tractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBoom Unit Pre-Operation Inspection and Service OPS-B- 0023E Hydraulic PUMP/OIL Reservoir Flail Head Inspection Do not Operate an Unsafe Tractor or Mower Tractor PRE-OPERATION Inspection Machine Controls Operating the Boom MowerEngaging Drive Operating Speed Wire TrapForward Speed Tractor PositionUpward Cutting Hedge Cutting ProcedureReversing Rotation Si Only Lift Float Kit Optional Flail Types Machine ConfigurationDriving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Transport Position Driving the Tractor and Boom Operating Instructions Operating the Tractor and ImplementSGM-08 Foreign Debris Hazards Bystanders/Passersby PrecautionsEngaging the Power Take Off PTO Operating the Mower Operating Speed and Ground SpeedSGM-08 Shutting Down the Attached Head TRACTOR, BOOM, and Attached Head Storage Transporting on Public Roadways Transporting the Tractor and ImplementOperation Operation Hauling the Tractor and Implement Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section General LubricationOil Supply Filtration MaintenanceHydraulic System Float KIT Accumulator TestFlailhead Hydraulic PumpsReplacing Damaged or Worn Spool O Rings Cable Operated Armhead Control ValveMain Relief Valve CablesNon-Return Valve Reach Ram Ram Seal Replacement General InformationHydraulic Rams Angling ArmRelief Valve Rotor Control VALVE/RELIEF ValveO. Gearbox Hydraulic MotorReplacing Shaft Seals Hose ReplacementHose Warranty Hydraulic HosesALAMO-INDUSTRIAL To the OWNER/OPERATOR/DEALER PA91-SOM-02/08 7191852C Printed U.S.A