OPERATION OF THE MULTI ZONE OUTPUTS WITH THE REMOTE CONTROL FROM ZONE A
The following operations can be performed when using an RC101 remote controller (sold separately).
CHANGE THE ZONE CONTROL COMMANDS (RC101) FOR ZONE A
ZONE A output can be operated from a room where the unit is not installed. This requires a separately sold IR receiver. (For connections, see page 21.)
(When operating the unit by Multi ZONE connected)
•ZONE A: ZONE A Control (Default)
•ZONE B: ZONE B Control
Change the control commands for each ZONE.
2.
1.
Notes for the Multi ZONE System
•If the Tuner (FM or AM) is active in the main ZONE, you can not control any function of the tuner. In this case, You must listen to the same station as the main ZONE.
•DMP (USB) operations cannot be performed using RC101 (sold separately).
OPERATION OF THE MULTI ZONE OUTPUTS WITH THE REMOTE CONTROL FROM ZONE B
The following operations can be performed when using an RC101 remote controller (sold separately).
CHANGE THE ZONE CONTROL COMMANDS (RC101) FOR ZONE B
ZONE B output can be operated from a room where the unit is not installed. This requires a separately sold IR receiver. (For connections, see page 21.)
Change the control commands for each ZONE.
2.
1.
1. Press SET button and ZONE button until the SEND indicator blinks twice.
Then backlight flashes.
|
| ENGLISH |
|
| |
OPERATION OF THE ZONE SPEAKER OUTPUTS | ANDNAMES | FUNCTION | |||
WITH THE REMOTE CONTROL | |||||
|
| ||||
To switch to ZONE SPEAKER SYSTEM A control, |
|
| |||
perform the following operations with the RC101 set |
|
| |||
to ZONE A. |
| BASIC | CONNECTIONS | ||
1. | 3. | ||||
|
| ||||
|
|
| |||
2. | 1. |
|
| ||
1. | the SEND indicator blinks twice. | OPERATION | |||
Press SET button and POWER ON button until | BASIC | ||||
| Then backlight flashes. | ||||
|
|
| |||
2. | Press the DVD button. | ADVANCED | CONNECTIONS | ||
Note |
|
| |||
|
|
|
| ||
Press the TV button at this time to return to the ZONE settings.
1. Press SET button and ZONE button until the SEND indicator blinks twice.
Then backlight flashes.
2. Press A ZONE button.
When the procedure is successful, the SEND indicator will blink twice.
2. Press B ZONE button.
When the procedure is successful, the SEND indicator will blink twice.
These buttons change a special code of each ZONE.
3. Press ENTER button once to lock in the code.
When the procedure is successful, the SEND | SETUP | |
indicator will blink twice. | ||
|
These buttons change a special code of each ZONE.
POWER ON/OFF 
SOURCE
VOL +/–
MUTE
POWER ON/OFF | ADVANCED OPERATION |
SOURCE | TROUBLESHOOTING |
| |
| OTHERS |
65