2 3 2 3 5, English, Preset Mode, Others | Marantz SR6003 instruction

	ENGLISH

NAMES	BASIC OPERATION (REMOTE CONTROLLER)
NAMES

PRESET MODE

PROGRAMMING WITH THE 4-DIGIT CODE

SCANNING THE CODE TABLE

	AND FUNCTION	NORMAL MODE
		(When operating Marantz AV equipment products)
		This remote controller is preset with a total of 12 types
	BASIC CONNECTIONS	of remote codes, including Marantz TV (television),
		DVD, VCR (VCR deck), DSS (satellite broadcasting
		tuner), TUNER, CD, CD-R, DMP, TAPE (tape deck),
		AUX1, AUX2, and AMP (ampliﬁer).
		Learning is not necessary for Marantz products. You
		can use these products without setting any codes.
		1. Press the SOURCE button.
	BASIC
		For this example, press DVD.
		Pressing the SOURCE button once changes
		the remote control to the settings for the source
	OPERATION
		that was pressed.
		To change the ampliﬁ er on other source, press
		the SOURCE button twice (double-click). The
		code is sent, and then the ampliﬁ er source
	ADVANCED CONNECTIONS	changes to DVD.
		SETTING THE BACK LIGHT
		Pressing the Light button located on the side of
		the remote controller lights the remote controller’s
		backlight.Pressing the button again while the backlight
		is lit lights the backlight for another 2 seconds.
	SETUP	To turn off back light, press and hold down the SET
		and OFF button until indicator blinks twice.
		To turn on it again, press and hold down the SET and
		ON button until indicator blinks twice.

		Initial is back light ON.
	ADVANCED OPERATION
	TROUBLESHOOTING
	OTHERS

(When operating non-Marantz AV equipment products)

This remote controller is preset with remote control codes from AV equipment by other manufacturers. The preset codes are TV, CD, DVD and DSS. Settings can be made in one of two ways.

When the preset codes are set, the following codes are contained in the source button of the remote controller.

See the attached manufacturer number list for the preset manufacturers, devices, preset numbers, and other settings.

Remote controller	Corresponding preset	Device name
source name	code
TV	TV	Television
DVD	DVD	DVD player
CD	CD	CD player
DSS	SATELLITE	Satellite broadcasting
		tuner equipment

Importants:

•Some codes may be not match your equipment.

In this case, you can use LEARN mode to store these codes.

•The preset codes do not cover full functions.

If you need extra function, use LEARN mode to store extra function.

•When the batteries are getting weak, the preset procedure is not successful.

1.	2.

1. Press and hold down the SOURCE button for the appliance which should be controlled and press SET button until the indicator blinks twice.Then back light ﬂushes.

2. Press the 4-digit code by numeric buttons for appliance (code table at the end of this book) Display 4-digit code on the LCD.

When the procedure is successful, “OK” is displayed on the LCD.

Note:

If “NG” is displayed on the LCD, then repeat steps 1 through 2 and try entering the same code again.

2.

1. Switch on the appliance which should be controlled.

2. Press and hold down the SOURCE button for appliance which should be controlled and press SET button until the indicator blinking twice. Then back light ﬂushes.

3. Aim the remote control at the appliance and slowly alternate between pressing INPUT 3 button and the SOURCE ON/OFF button for the appliance.

Display the setup number on the LCD.

4. Stop when the appliance turns off.

5. Press ENTER button once to lock in the code.

BASIC OPERATION (REMOTE CONTROLLER)

PRESET MODE

SCANNING THE CODE TABLE

2.