Marantz SR6003 English, Checking The Code, Resetting The Code, Learn Mode, Learning Procedure

CHECKING THE CODE			RESETTING THE CODE
				1.
	1.	2.		1.
		3.
	1.	4.		2.
1.	Press and hold down the SOURCE button for		1. Press and hold down the SOURCE button
			for appliance which should be controlled and
	appliance which should be controlled and press		press SET button until the indicator blinking
	SET button until the indicator blinking twice then		twice.
2.	back light flushes.		Then back light flushes.
	Press the INFO button.		2. Press the below codes to reset.
	The indicator will blink twice.		TV	: 1000
3. To setup code for all digits is displayed on the			DVD : 2000
			CD	: 3000
	LCD in 3 seconds.

DSS : 4000

Note:

After this procedure, the selected SOURCE button is set initial code.

LEARN MODE

This remote controller is capable of learning and storing codes used by other remote controls that you already own.

For codes which are not learned, the remote controller will transmit either the Marantz preset codes from the initial settings, or remote codes from another manufacturer’s AV equipment which is set by the customer.

The receiver sensor for the remote controller signals is located at the top of the remote controller.

Notes:

•This remote controller is capable to learn around 120 codes.

•When the batteries are getting weak , the learning procedure is not successful.

LEARNING PROCEDURE

1. Place the remote controller so that its infrared signal transmitter is facing the infrared signal receiver on the Marantz remote controller at a distance of about 0.05 m (2 inches).

			ENGLISH
4.	Select the button to be learned.			NAMESAND	FUNCTION
	• LEARN indicator stop to blink.
Notes:
	• The learning function is unavailable for all SOURCE
	buttons and HDMI button in any mode.
	• The learning function is unavailable for all buttons				CONNECTIONS
	in TUNER mode and AMP mode.			BASIC
5.	LCD.
	Press and hold the button of the original remote
	controller to learn until “OK” is displayed on the
				OPERATION
	• When “NG” is displayed on the LCD, repeat			BASIC
		this step.
				ADVANCED	CONNECTIONS
	• When the memory of the remote controller
		is full, “FULL” is displayed on the LCD. If you
		want to learn the code, you should erase
		other learned button.
				SETUP

2.

3.

Press and hold down the SET and SETUP buttons until LEARN indicator blinks.

Select the SOURCE button to select the SOURCE, the SOURCE name is displayed on the LCD.

6. Repeat steps 4 and 5 to learn other buttons in same SOURCE.

7. Repeat steps 3 to 6 to learn other SOURCE.

8. When you have finished programming the remote controller, press the SET button, then LEARN indicator stops blinking and exits from the LEARN mode.

Notes:

•When “NG” is displayed on the LCD once again, the transmitting code is unavailable for remote controller, or the transmitting signal is intercepted by noise.

•If no buttons are pressed for approximately 1 minute while in the LEARN mode, the remote controller automatically exits from the LEARN mode.

OPERATION

ADVANCED OTHERS TROUBLESHOOTING

69