REPAIRS
inlet.
14.Connect and adjust the gas and choke wires (see below).
15.Check that the oil drain valve is closed and fill the engine with oil (see Delivery Servicing\Delivery Service).
16.Connect the positive cable (red) to the battery’s positive terminal.
17.Open the fuel valve.
Dismantling and Assembling
Adjustments and Specific Repairs
See the Kawasaki Service Manual for the engine and auxiliary systems.
Troubleshooting
See section 8 of the Kawasaki Service
Manual.
The above section contains a troubleshooting guide for the engine and auxiliary systems. It also has separate troubleshooting instructions for the starter motor.
Adjusting the Throttle Wire
Adjusting Throttle Lever Tension
If there is insufficient throttle lever friction, throttle settings can alter while the mower is being operated. This can be corrected via the lever’s pivot bolt.
1.Free the control console and pull forwards.
2.Tighten the throttle lever’s pivot bolt.
Checking and Adjusting the Throttle Wire
Check that the engine responds to the throttle control and that the correct engine speed is achieved at full throttle.
If adjustment is necessary, adjust the lower wire as follows:
1.Loosen the clamping screw holding the wire’s outer casing and set the lever to the full throttle position.
2.Check that the throttle wire is attached to the correct hole in the lower lever, see
Freeing the controle console
Checking and adjusting the throttle wire