Samsung SCC-C6403P ZONE AREA, LOCATION, ZONE ID SET, ZONE ENABLE

ZONE AREA

Press [ENTER] to enter the ZONE AREA MAP screen from “ZONE AREA SET...”. Select a ZONE AREA number from the ZONE AREA MAP screen and press [ENTER] to enter the ZONE AREA setup screen.

(ZONE SET)				(ZONE AREA MAP)
ZONE DIR SET	OFF
		➜		0	*	1	2	3
ZONE AREA SET	ON...
			4			5	6	7
		Press
		[Enter]
EXIT	QUIT

	ZONE AREA SET	0
➜		...
	LOCATION
	ZONE ID SET	...
Press	ZONE ENABLE	ON
[Enter]
	EXIT	QUIT

LOCATION

The “LOCATION...” menu designates the left/right LIMIT positions of ZONE AREA. Enter the setup screen to move PAN, then select a start position and press [ENTER]. Move PAN again

to select a end position and press [ENTER]. Now, ZONE AREA setup is complete.

ZONE AREA SET		0
				SET START!
		...
LOCATION					➜
ZONE ID SET		...	➜
						E
ZONE ENABLE		ON
					After P/R/Z
			Press
					control, press
			[Enter]
					[ENTER]
EXIT		QUIT
	SET END!

After PAN control, press [ENTER] to finish.

ZONE ID SET

This function is used to allocate as many as 12 IDs to each zone area. Use Left , Right, UP, or DOWN for this purpose. You may select the ID position from the additional menu of “LOCATION...”.

			ZONE AREA ID 0
ZONE AREA SET	0
					B C D E F G H I J K L
LOCATION	...	➜		A
ZONE ID SET	...			M N O P Q R S T U V W X
ZONE ENABLE	ON			Y Z 0 1 2 3 4 5 6 7 8 9
		Press			: ! - + ✻ ( ) /
				SP ïî SP
		[Enter]		LOCATION...
				RET
EXIT	QUIT				ZONE 0........

ZONE ENABLE

This function turns on or off the ZONE AREA ID indication.

3-20 3-21