Samsung VP-DX10 Method 3:Using a DVD disc, 35_ English, 方法 3: 使用 DVD 光盘, 中文 _35, pickup lens

Method 3: Using a DVD disc

•When inserting a disc or closing the disc cover, do not apply excessive force. It may cause a malfunction.

•You cannot open the disc cover while loading.

•You can use a new 3 1/2 inch(8cm) DVD-RW, DVD+RW, DVD-R or DVD+R DL (Dual Layer) disc for movie recording. Photos can not be recorded onto a DVD disc. A DVD disc is available only in the movie mode.

方法 3: 使用 DVD 光盘

当 插入光盘或关闭光盘舱盖时，不要用力过大。否则会造成

1		损坏。
����		在载入光盘的过程中，不可以打开光盘舱盖。
		您可以使用新的 3 1/2 英寸 (8cm)DVD-RW, DVD+RW, DVD-R 或
		DVD+R DL ( 双层 ) 光盘用来录制影音。DVD 光盘不能记录照
		片图像。DVD 光盘仅可使用在录制影音模式。

Inserting a disc

1.Slide the OPEN switch in the direction of the arrow.

•The disc cover will partially open.

2.Gently open the cover the rest of the way by hand.

3.Push the disc into the disc compartment until a click is heard.

•The recording side of the disc must face the inside of the DVD camcorder.

•Do not touch the pickup lens.

4.Gently push the disc cover to close it.

•Once inserted, the disc is recognised and the ACCESS/ CHG indicator blinks. Do not cut off the power supply during this time. Do not shake nor apply impact. It may cause a malfunction.

•To select the DVD disc as your recording storage media,

touch Menu ( ) tab  Storage ( , , ) tab  “DVD.”

•Move the grip belt so it does not interfere with inserting or ejecting the disc.

•The disc cover can be opened when the device is connected to an AC power adaptor or the battery pack, even if the power is off.

•When you insert a DVD disc in STBY mode, the storage media setup menu appears.

Caution

This product utilizes a laser. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do not open covers and do not look inside the product if interlock mechanism is damaged.

Warning

Be careful not to damage the interlock mechanism.

3

4

pickup lens

插入光盘

1.依照箭头方向推动 OPEN 开关。

光盘舱盖被打开。

2.用手柔和地打开舱盖。

3.将光盘放入光盘插槽内直到听见一声轻响。

光盘的刻录面必须面向 DVD 摄像机的里面。

不要触摸激光头物镜。

4.轻轻扣上光盘舱盖。

一旦设备开始识别光盘，ACCESS/CHG 指示灯便开始闪烁。 在此期间，不要切断电源。不要震动，撞击它，以免造 成损坏。

要选择 DVD 光 盘 作 为 录 制 存 储 介 质， 请 触 摸 菜 单

( ) 导航 
存储器 ( , , ) 导航

“DVD”。

移动手带不会影响插入或取出光盘。

当 交流电源适配器或电池组连接到设备时，即使电源为关闭状 态，光盘舱盖也可以打开。

当在 STBY( 待机 ) 模式下插入 DVD 光盘时，屏幕上显示存储 介质设置菜单。

注意

本产品使用激光技术。如果您未按本文的规定使用控制、调节或执行操作， 则可能会遭受危险的激光辐射。若连锁机制已经损坏，请不要打开舱盖或自 行拆卸本产品。

警告

请务必小心不要损坏连锁机制。

35_ English 中文 _35