lWhenreplacingt heprojector lamp:
oPutthe projector into Standby modeand wait 30 minutes for the lamp to cool
completely.
oDonot remove any screws other than those specified in the lampreplacement
instructions.
oWearprotective eyewear while changingthe lamp. Failureto do so c ancause injuries
includingloss of eyesight if t helamp shatters or bursts.
oUseonly replacement lamps approvedby SMARTīTechnologies.Contact y our
authorizedSMART resellerfor replacement parts.
oNeverreplace the lampass emblyw ith a previously usedlamp assembly.
oAlways handlethe fragile lampass embly with care to preventprematurelamp failure or
exposureto mercury. Use gloves when touchingthe lamp. Do not touch the lamp with
yourfingers.
oRecycle ordispose of the lamp as hazardous waste in accordancewit h local
regulations.
Youneed a Phillips No. 2 screwdriver anda fl at screwdriverto c ompletethese procedures.
gTo removethe old lamp
1. Pressthe Power button twice on the remotec ontrolor the ECP to put t heprojector into
Standbymode.
2. Wait at least 30 minutes fort heprojector to cool down.
3. Disconnectt hepower cable from the wall outlet.
CH A P T E R 5
Maintainingyour interactivew hiteboard system
38