>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58
Powerstate controls
Thesecommands put the projectorin and out of Standby modeand request the projector’scurrent
powerstate. The projector’s powerst atedetermines whether certaincommands are availableat that
time.These settings are available evenw henthe projector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
offnow powerstate=[field]
offlow power powerstate=[field]
getpowerstate powerstate=[field]
Thefollowing table describest hepower state commands:
Command Description
on Turnson the projector.
off Startst hes hutdownprocess. A dialog box appearswit h the
message,“Press Power Button to Turn off Projector.”Y oumust send
asecond Off commandwit hin10 seconds to put the projector into
Standbymode.
offnow Shutsdown the projector immediately.Y oucan’t delay or cancel this
command.
offlow power Thedevice’s current power state. Different devices have different
potentialpower states. These powers tates shouldmatch t hepower
states foundin the attached projector.
getpowerstate Indicatesthe projector’s currentpower state.
Thefollowing table describest hepower state fields:
Field Description
Powering Theprojectoris turningon.
On Theprojector is on.
Cooling Theprojectoris cooling.
Confirmoff Confirm off is a non-selectablepowerstate that is returnedduring
stageone of the two-button Offsequence.
Idle Theprojectoris off but still receiving power(Standby mode).
AP P E N D I X B
Remotelymanaging your system throu gh an RS- 232 serial interface
71