Sourceselectioncontrols
Thesecommands switch inputs ources.The sourcet ypedetermines whichc ommandscan be
accepted.
Command Response Available in Standby
mode
getinput input=[field] Yes
setinput=[field] input=[field] No
Thefollowing table describest hesource selection commands:
Command Description
getinput Returnsthe projector’s currentinput.
setinput=[field] Sets theinput to one of the selectable fields.
Thefollowing table describest hesource selection response fields:
Field Description
VGA1 Switches sourcet o theV GA 1 inputc onnector.
VGA2 Switches sourcet o theV GA 2 inputc onnector.
Composite Switches source to the Composite video connector.
If you installedy ourinteractive whiteboards ystem accordingt o the
instructions,this is therelay from the ECP.
HDMI Switches source to the HDMI inputport.
None Anon-selectable valuethat appears when you entera “get input”
commandwhile the projectoris inStandby mode.
Generalsource controls
Thefollowing source controls applyto all input sources. HD MI connectors ourcecontrols are
describedin this section. These controls areunavailable when the projectoris in Standby mode. You
canspecify customcolor values for all inputs.
Thesecommands informy ouof thecurrent sources ettings.
Command Response
getdisplaymode displaymode=[currentdisplaymode setting]
getbrightness brightness=[currentbrightnesssetting]
getcontrast contrast=[currentcontrast setting]
getwhitepeaking whitepeaking=[currentwhitepeakingsetting]
getdegamma degamma=[currentdegammasetting]
getred red=[currentred colors etting]
getgreen green=[current greencolor setting]
AP P E N D I X B
Remotelymanaging your system throu gh an RS- 232 serial interface
72