gTo put thenew lamp module into the projector
1. Removethe new lamp modulef romits packaging.
2. Carefullyplace the lamp moduleinto the projector usingt hehandle on the top of the module.
Holdthe lamp modulev ertically andguide it into its slot.Gently press t hepower end of the
lampmodule againstthe projector to ensurethe power plug makes contact with the projector’s
powerreceptacle.
3. Uset hePhillips screwdriverto tighten the captive screws.
4. Carefullyslide the lamp cover back onto the projector.
5. Connectthe power cable to the wall outlet.
6. Pressthe Power button onceon the remote control orEC P to confirm that the projectoris
operatingandthat the lamp moduleis correctlyinstalled.
7. Putthe old lamp in a secure container,and handleit gentlyuntil you recycle it.
gTo finish theprojector lamp installation
1. Turnon the projector.
2. Access the service menut o resett helamp hour counter(see Resetting the lamp hours on next
page).
3. Activate the projector’salert e-mails andlamp warnings if they’ve been deactivated(see E-mail
alerts onpage65 and Control panel onpage 60).
CH A P T E R 5
Maintainingyour interactivew hiteboard system
40