lIna high altitude location over6000' (1800m), wherethe air is thin and coolingeffic iency is
reduced,use the projectorwith the fan mode set to High.
lCyclingpower to the projector repeatedlycan lock or damagey ourSMART product.After
youput the product into Standbymode, wait atleast 45 minutes for cooling beforest arting
theproduct again.
lIf dust or small items prevent pentray buttons from being pressedor cause constant button
contact, removethe obstructions carefully.
II M P OR T A N T
lIf you haveperipheraldevices that do not use a 4-pin mini-DIN S-video connector,an RC A
Compositevideo jack or an HDMI v ideoconnector, or if your device has an audioconnection
thatdoes not use RCA jacks, you may needto purchase third-partyadapters.
lThereareno projector menuoptions on the ECP. Keep your remotec ontrolin a safe place
becausethe ECP is not a s ubstitute for the remotecontrol.
lDonot disconnect cables from the ECP t o connectperipheraldevices because you could
disconnectcontrols for your interactive whiteboard.
lDisconnectt heproduct from its power source when it’s not used for a long period.
Cleaning
CC A U T I O N
lBeforeyou clean the projector,press the Power button twice on the ECP or remote
controlto put the syst emi n Standbymode, and then allow the lampto c oolf orat least30
minutes.
lDonot spray cleaners, solvents or compressed airnear any part of the projectorbecause
theycan damage ors tain theunit. Sprayingthe system could spread a chemicalmis t on
someof the projector’s componentsand lamp, resulting in damageand poorimage quality.
lDonot allow liquids or commercial solvents of any kind to flow intothe projector.
IM P OR T AN T IN F O R M A T I ON
iv