■ The air is as free from dust as possible.
■ The unit is installed in a clean, air conditioned environment.
■ No more than four Switch units are placed on top of one another, if the units are
| ■ The Switch is situated away from sources of conductive (electrical) |
| dust, for example laser printers. |
| ■ The AC supply used by the Switch is separate to that used by units |
| that generate high levels of AC noise, for example air conditioning |
| units and laser printers. |
|
|
| The Switch is 1.5U and will fit in most standard |
| as each Switch requires a shelf or runner to support its weight, you may |
| need to allow a 2U space within the rack for each Switch. |
| WARNING: The Switch should only be used in a rack if it is mounted on |
| runners, a shelf, or a tray to support the weight. The |
| alone are not sufficient to support the weight of the switch. The rack- |
| mount kits must not be used to suspend the Switch from under a table or |
| desk, or attach it to a wall. |
| CAUTION: Disconnect all cables from the Switch before continuing. |
| Remove all self adhesive pads from the underside of the Switch if they |
| have been fitted. |
| CAUTION: You must use a shelf or support that will not obstruct the air |
| flow through the side panels of the Switch. |
| To |
| 1 Place the Switch the right way up on a hard flat surface, with the front |
| facing towards you. |
| 2 Locate a securing bracket over the mounting holes on one side of the |
| Switch, as shown in Figure 9. |
| 3 Insert the three screws and tighten with a suitable screwdriver. |
