3Com FE100 manual Microsoft Cluster Server suc

7DEOH￿￿￿￿￿￿￿7URXEOHVKRRWLQJ￿￿FRQWLQXHG￿

3UREOHP	3UREDEOH￿&DXVH	&RUUHFWLYH￿$FWLRQ
Attempts to connect to a clus-	The Cluster Service has not	Verify that the Cluster Service has been
ter using Cluster Administrator	been started, a cluster has	started and that a cluster has been
fail.	not been formed on the sys-	formed. Use the Event Viewer and look
	tem, or the system has just	for the following events logged by the
	been booted and services	Cluster Service:
	are still starting.
		Microsoft Cluster Server suc-
		cessfully formed a cluster on
		this node.
		or
		Microsoft Cluster Server suc-
		cessfully joined the cluster.
		If these events do not appear, refer to the
		Microsoft Cluster Server Administrator’s
		Guide for instructions on setting up the
		cluster on your system and starting the
		Cluster Service.
You are prompted to configure	The Transmission Control	The node-to-node network and public LAN
one network instead of two	Protocol (TCP)/IP configura-	must be assigned static IP addresses on
during Microsoft Cluster Server	tion is incorrect.	different subnets. See “Installing and Con-
installation.		figuring Additoinal NICs in a Cluster” in
		Chapter 3 of this guide for information
		about assigning the network IPs.

You are unable to administer the cluster from a remote system.

The remote system is running Service Pack 3 and you are trying to administer a cluster running Service Pack 4.

Upgrade the remote system to Service Pack 4 or administer the cluster from a system running Service Pack 4.

Troubleshooting 5-3