2-10 CHAPTER 2: DUAL T1/PRI CONFIGURATION
Configuring Inbound Call Routing
Configure inbound call routing by selecting option 4 from the UI console’s
main menu.
Pressing option 4 at the main menu prompt produces this screen:
Menu Option 1 Selecting a Gateway to process digital calls
Digital calls handled by the T1/PRI are passed alon g to an ISDN-GW
(ISDN-Gateway (NETServer PRI)) in the Total Control chassis to be
processed. The T1/PRI must be configured as to the location (chassis slot
number) of the ISDN-GW it is to communicate with.
The ISDN-GW is located in slots 1–16 of the Total Control chassis.
If no Gateway is installed, enter N at the prompt.
Menu Option 2 Allowing modem analog calls
Enabling this option allows the chassis to accept incoming analog modem
calls and route them appropriately.
Copyright | 3Com Corporation, 1998
Dual T1/PRI Application Card Revision 3.1.4 (Card Id : 27 )
Boot Code Linked Date : Mon Dec 04 17:41:48 1995
Operation Code Linked Date: Tue Feb 23 16:41:51 1999
Main Menu
1 Command
2 Status
3 Card Configuration
4 Inbound Call Routing Configuration
5 Span Line 1 Configuration
6 Span Line 2 Configuration
7 SW Fault Manager Event Logging
8 Logout
Enter menu selection and press Return.
Menu Selection (1-8):
Inbound Call Routing Configuration
Current
1 Default ISDN-GW Slot: 16
2 Allow Analog Modem Calls: Disabled
3 Inbound Phone Number Routing Configuration
4 Inbound Phone Number Routing Configuration Status (Entries 1-24)
5 Inbound Phone Number Routing Configuration Status (Entries24-48)
6 Reserved Pool to Inbound Phone Number Assignment
7 Modem/ I-Modem to Reserved Pool Assignment
8 ISDN-GWC to Reserved Pool Assignment
9 Allow ISDN-GWC
Enter menu selection and press Return or press Esc to exit.
MSli(18)