Chapter2. Installing 3Com VCX IP Telecommuting Module
TelecommutingModule). The network mask determines the number of computers that can act as configuration
computers.
Networknumber [0.0.0.0]: 10.47.2.0
Netmask/bits[255.255.255.0]: 255.255.255.0
Ifthe network or partial network is not directly connected to the Telecommuting Module, you must enter the IP
addressof the router leading to that network. Then enter the network’s address and mask.
Staticrouting:
Thenetwork allowed to configure from is not on a network local to this
unit.You must configure a static route to it. Give the
IPaddress of the router on the network this unit is on.
TheIP address of the router [0.0.0.0]: 10.47.3.1
Networkaddress [10.47.0.0]: 10.10.0.0
Netmask[255.255.255.0]:
Thenenter a password.
Password[]:
Finally,you are asked if you want to reset other configuration.
Otherconfiguration
Doyou want to reset the rest of the configuration? (y/n) [n]
Ifyou answer n, nothing is removed. If you answer y, you have three alternatives to select from:
1.Clear as little as possible. This is the alternative that is used if you answer nto the question above. Both the
preliminaryand the permanent configurations will be updated with the configuration specified above.
2.Revert to the factory configuration and then apply the configuration specified above. This will affect the
permanentbut not the preliminary configuration.
3.Revert to the factory configuration and empty all logs and then apply the configuration specified above. Both
thepreliminary and the permanent configurations will be affected.
Selectthe update mode, which is what you want to remove.
Updatemode (1-3) [1]:
Allconfiguration is now complete. The installation program shows the configuration and asks if it is correct.
yessaves the configuration.
noruns the installation program over again.
abortends the installation program without saving.
8