Chapter3. Configuring 3Com VCX IP Telecommuting Module
loggingwanted under Logging. This is also where the logs of traffic through the Telecommuting Module are
viewed.
Whenthe configuration is complete, apply it. Go to Save/Load Configuration under Administration. Select
Applyconfiguration. Now the new configuration is tested. Save it permanently if it works satisfactorily. If the
configurationis not satisfactory, select Revert or restart the Telecommuting Module. The old configuration will
remain.
Preliminary and permanent configuration3ComVCX IP Telecommuting Module has two kinds of settings: preliminary and permanent configuration. When
theTelecommuting Module is running, the permanent configuration controls the Telecommuting Module functions.
Whenyou configure your Telecommuting Module, you are working with the preliminary configuration. As you
changethe preliminary configuration, the permanent configuration continues to control the Telecommuting Module
functions.
Whenyou are done with the preliminary configuration, you can test it by selecting Apply configuration on the
Save/LoadConfiguration page. Now the preliminary configuration controls the Telecommuting Module functions.
Whenyou are satisfied with the preliminary configuration, you can apply it permanently, which copies the
preliminaryconfiguration to the permanent configuration. Now the new configuration controls the Telecommuting
Modulefunctions.
Youcan also copy the permanent configuration to the preliminary configuration. This does not affect the permanent
configurationor the Telecommuting Module functions, which are still being run by the permanent configuration.
Youdo this by selecting Abort all edits on the Save/Load Configuration page under Administration. This will
discardall changes made in the preliminary configuration since last time you applied a configuration by pressing
Saveconfiguration.
16