Chapter5. The Serial Console
Staticrouting:
Thenetwork allowed to configure from is not on a network local to this
unit.You must configure a static route to it. Give the
IPaddress of the router on the network this unit is on.
TheIP address of the router [0.0.0.0]: 10.47.3.1
Networkaddress [10.47.0.0]: 10.10.0.0
Netmask[255.255.255.0]:
Enterthe IP address of the router and the network to which the configuration computers are connected. This could
bea bigger network than the one entered to distinguish the configuration computers.

Password

Seta password for the Telecommuting Module here.
Password[]:
Notethat the password will be printed on the screen when entered. It will also be shown when all settings are made.
Other
Youcan also select if all other configuration should be removed or not.
Otherconfiguration
Doyou want to reset the rest of the configuration? (y/n) [n]
Ifyou answer n, nothing is removed. If you answer y, you have three alternatives to select from:
1.Clear as little as possible. This is the alternative that is used if you answer nto the question above. Both the
preliminaryand the permanent configurations will be updated with the configuration specified above.
2.Revert to the factory configuration and then apply the configuration specified above. This will affect the
permanentbut not the preliminary configuration.
3.Revert to the factory configuration and empty all logs and then apply the configuration specified above. Both
thepreliminary and the permanent configurations will be affected.
Updatemode (1-3) [1]:
Whenall settings are entered, they are shown on the screen to be confirmed.
Isthis configuration correct (yes/no/abort)?
yeswill make the Telecommuting Module reboot using the new settings.
nowill make the Telecommuting Module go through the Basic configuration questions again and allow you to
changesettings.
abortwill make the Basic configuration script end without changing any settings.
Save/Load configuration
Here,you can save your configuration to a file or load a configuration from a file. The transfer is made using the
Zmodemprotocol, which can be found in terminal software such as Hyperterminal.
39