Chapter5. The Serial Console

Deactivate other interfaces

Ifthe Telecommuting Module has been used one or more interfaces are active. Select here if all interfaces but the
oneselected above should be deactivated. You can activate them again via the web GUI.
Configuration computers
Enterhere the computers from which it is allowed to configure the Telecommuting Module. The computers entered
hereare the only ones allowed to access the web GUI.
Selectbetween allowing a single computer or an entire network.
Computersfrom which configuration is allowed:
Youcan select either a single computer or a network.
Configurefrom a single computer? (y/n) [y]

Configure from a single computer

Ifconfiguration of the Telecommuting Module should be allowed from a single computer only, answer yto the
questionabove. Then enter the IP address of the configuration computer.
IPaddress [0.0.0.0]: 10.47.2.240
Ifthe configuration computer is on the same network as the Telecommuting Module, these are all configuration
settingsneeded. If the configuration computer is on a different network, the Telecommuting Module will ask for
routingto that network.
Staticrouting:
Thecomputer allowed to configure from is not on a network local to
thisunit. You must configure a static route to it. Give
theIP address of the router on the network the unit is on.
TheIP address of the router [0.0.0.0]: 10.47.3.1
Networkaddress [10.47.0.0]: 10.10.0.0
Netmask[255.255.255.0]:
Tolet the Telecommuting Module know where traffic to the configuration computer should be sent to, you must
enterthe router it should use here. Enter the router which is on the same network as the Telecommuting Module and
whichis used to route traffic to the configuration computer.
Youshould also enter the network to which the configuration computer is connected.

Configure from multiple computers

Ifconfiguration of the Telecommuting Module should be allowed from more than one computer, answer nto the
questionabove. Then enter the network address of the network to which the configuration computers are connected.
Thiswill allow all computers on this network to configure the Telecommuting Module.
Networknumber [0.0.0.0]: 10.47.2.0
Netmask/bits[255.255.255.0]: 255.255.255.0
Enterthe network address and netmask for the configuration computer network. If they are on the same network as
theTelecommuting Module, these are all configuration settings needed. If the configuration computers are on a
differentnetwork, the Telecommuting Module will ask for routing to that network.
38