3M™ MicroTouch™ Software MT 7 User Guide 5
3M Touch Systems, Inc. Proprietary Information – 25695M
About This Manual

Introduction

This manual describes how to:
• Install 3M™ MicroTouch™ Software MT 7 for your touch system and specific
operating system.
• Use the MT 7 control panel to customize your work environment.
• Troubleshoot the sensor.
Before installing MT 7 software, you must complete the appropriate hardware
connections for your controller. For instructions, refer to your appropriate 3M™
MicroTouch™ Controller Reference Guide. All technical documentation can be found
on the 3M Touch Systems, Inc. website at www.3m.com/touch.
The drivers included in MT 7 will support the following:
• All current 3M™ MicroTouch™ controllers (no legacy controllers) and chipset
designs.
• Capacitive and resistive touch technologies
• Both USB and RS-232 communication protocols.

Sensor Care and Cleaning

The sensor requires very little maintenance. 3M Touch Systems, Inc. recommends that
you periodically clean the glass surface.
CAUTION
To reduce the risk of the potentially hazardous situations associated with the use
of isopropyl alcohol which may result in minor or moderate injury or property
damage:
Follow all instructions and recommendations in the alcohol manufacturer's Material
Safety Data Sheet and product label.
Typically, an isopropyl alcohol and water solution ratio of 50:50 is the best cleaning
agent for your sensor. You can also use straight isopropyl alcohol. Be sure to follow
solvent manufacturer's precautions and directions for use when using any solvents.