58 | 3M™ MicroTouch™ Software MT 7 User Guide |
Check the following items:
1.Make sure the touch controller is connected to the correct port.
2.Review the installation procedures and verify all hardware is properly connected. Check the serial port and sensor cable connections. Check that the sensor and controller cables do not have any kinks and that connector pins are not bent.
3.Reset the sensor and its controller. Turn off both the computer and the display, wait a few minutes, and then turn on each device again.
Touch Driver Did Not Load
Check Windows® device manager under mice and pointing devices to see if the MicroTouch drive is loaded and running without errors (under system devices for the MicroTouch bus driver (used only for EX serial sensors)).
If these are missing, run Installdriver.bat inside WINNT\Program Files\
MicroTouch\MT7 to reload the driver.
If this does not work then run Removedriver.bat, reboot then rerun Installdriver.bat.
Right-click Tool Buttons Are Swapped
Using the control panel, it is possible to change which button on a mouse generates the "left" and "right" clicks. This feature allows
To address this, edit the file "TwFactory.cfg" in the MT 7 for Windows™ software directory. If this file is empty, add in the text:
<Touch>
</Touch>
Between these two lines, add a new line:
SwapMouseButtons=1
Save the file.
Open a command line window and set your working directory to the MT 7 for
Windows™ directory. Issue the command: TwCfgUtil / u TwFactory.cfg
At this point, your touches start producing the desired
If your system supports multiple users, you may need to create separate files, such as TwLeft.cfg and TwRight.cfg. In TwLeft.cfg, set SwapMouseButtons to 1 and in TwRight.cfg, set SwapMouseButtons to 0.
Add the above TwCfgUtil to each user's Startup menu or login script, using TwLeft.cfg or TwRight.cfg as appropriate.
3M Touch Systems, Inc. Proprietary Information – 25695M
