Adaptec PCI Ethernet and Fast Ethernet Adapters manual Testing the PCI Configuration

Installing Your Adapter

Testing the PCI Configuration

Use EMDIAG to make sure the PCI adapter is configured properly. For more information about EMDIAG, see Chapter 5, Using EMDIAG to Troubleshoot Problems.

1Type A:\EMDIAG and press Enter to start the Adaptec setup program.

2At the Main Menu, select Configuration Status.

3The Configuration Status screen reports the resources in use by the adapter.If the adapter has encountered a resource conflict with another adapter, or is not yet fully configured, EMDIAG displays an error message.

Try repeating the installation and configuration procedures again. If you still have difficulties, refer to Chapter 5, Using EMDIAG to Troubleshoot Problems.

Testing the Quartet Configuration

If you are planning to use your quartet with Windows NT you must first determine if your system's BIOS supports the PCI-to-PCI bridge chip.

1At EMDIAG's Main Menu, select PCI Device Information. A screen similar to the following appears:

2-5

PCI Ethernet and Fast Ethernet Adapters User’s Guide

Stock Number: 511472-00, Rev. A	Page: 2-5
Print Spec Number: 496708-00
Current Date: 5/5/97	ECN Date: 5/97