SCO Unixware SMP

The ANA-6944A/TX, ANA-6901A, and the ANA-6911A/TX UNIX drivers support SCO

Installing the Drivers

1Insert the Unix Drivers diskette into the first floppy drive (usually A).

2Make a directory for the driver, as follows:

3Change to the directory you just created, as follows: chdir adaptec

4Copy the files from the floppy diskette to the hard disk, as follows:

doscp a:\unixware\*.*.

5Extract the files, as follows:

tar -xvf -d adaptec\empci.tar

6To install the drivers, type:

./Install

The system loads the EMPCI modules and displays the following messages:

ADAPTEC: Adaptec (10/100) PCI Fast Ethernet

Installation

ADAPTEC: Please Enter the Card you are Installing (1/2)

1.Adaptec ANA-6911A PCI EM110

2.Adaptec ANA-6944A PCI EM4400

7Enter the number (1 or 2, as shown above) of the adapter you are installing. The system displays the following messages:

ADAPTEC: Netinfo EMPCI_0 EMPCI_1 EMPCI_2 EMPCI_3

ADAPTEC: Please use /etc/confnet.d/configure -i to configure the IP ad- dress

4-30

PCI Ethernet and Fast Ethernet Adapters User’s Guide