Adaptec PCI Ethernet and Fast Ethernet Adapters manual

Installing Network Drivers

The drivers are now displayed on the list of drivers.

4Click Add to add the drivers.

Note: If you added all four ports for the ANA-6944A/TX, OS/2 automatically loads as many drivers as you need when you reboot.

5Select the appropriate protocols and click Add.

Note: If you need to configure each port with different protocols, pay attention to the order of binding. The first device on your list installs the driver for port 1 (the top connector on the card and the furthest from the PCI bus connector). The second device loads port 2 (next to port 1), and so on.

6Shutdown OS/2 and reboot for your network driver and protocol(s) to take effect.

Installing the Drivers for a Pre-existing OS/2 SMP

Use the following instructions if you already have OS/2 SMP or OS/2 Peer Client installed on your machine. If you are installing OS/2 SMP for the first time, see Installing OS/2 SMP for the First Time on page 4-26.

1On your desktop, double-click the MPTS (Multi-Protocol Transport Services) icon.

2Select Install.

3Select Install Additional Network Drivers, and specify a:\ndis.os2 as the source. Select OK.

4After the OS/2 driver is copied from the diskette, select OK.

5Select Configure.

6Select LAN Adapters and Protocols and then click Configure.

7In the LAPS dialog box, under Network Adapters, highlight the ANA-6944A/TXand click Add. Repeat this three times to add the other three ports as separate devices.

4-25

PCI Ethernet and Fast Ethernet Adapters User’s Guide

Stock Number: 511472-00, Rev. A	Page: 4-25
Print Spec Number: 496708-00
Current Date: 5/5/97	ECN Date: 5/97