Adaptec PCI Ethernet and Fast Ethernet Adapters manual Windows 95 Installation for PCI

Installing Network Drivers

Windows 95

Note: Consult the \readme\win95.txt file for the latest driver information and installation instructions. Some procedures or information may have changed or may not have been available when this user’s guide was printed.

The Windows 95 driver is in the \win95 directory.

Windows 95 Installation for PCI

1Power OFF your system and install your Adaptec PCI adapter in any bus mastering PCI slot.

2After booting up Windows 95, the operating system detects any newly installed adapter, and requests that the driver diskette be inserted.

3Put the diskette in drive A and specify a:\win95 as the path to the driver.

4During the driver installation process, Windows 95 also requests the WIN95 CD-ROM or diskette so that configuration files can be copied from it.

5Make sure that at least one network client and one protocol are installed, in addition to the Adaptec adapter driver now listed under Control Panel/Network.

6To configure any of the parameters on the Adaptec adapter, highlight the adapter in the list of installed drivers and select Properties.

7After you have made all changes, Windows 95 will restart your system.

Windows 95 Driver Parameters

Connection To enable Full Duplex on PCI adapters only, select

Typeany one of InitSense/Full Duplex, ActiveSense/Full Duplex, 10 Mb/s UTP/Full Duplex, or 100 Mb/s UTP/Full Duplex (TX only). Requires connection to a switch or other device supporting Full Duplex.

4-19

PCI Ethernet and Fast Ethernet Adapters User’s Guide

Stock Number: 511472-00, Rev. A	Page: 4-19
Print Spec Number: 496708-00
Current Date: 5/5/97	ECN Date: 5/97