2.If a ground spacer (accessory) will not be installed, proceed to step 7. If a ground spacer will be installed, align the ends of the left ground spacer section with the ends of the right ground spacer section and then press the two sections together.
3.Place the assembled ground spacer in position for mounting on the adapter cover.
4.Align the mounting holes in the ground spacer with the mounting holes in the adapter cover.
5.Secure the ground spacer to the adapter cover using the four capscrews, four lock washers, and four flat washers provided with the cabinet. Tighten all capscrews securely.
6.Open the rear door of the cabinet and remove the back section of the cabinet bottom cover as described in Section 5.1. Then return to step 7 of this procedure to finish mounting the cabinet.
7.Using appropriate lifting equipment, hold the cabinet in position for mounting onto the ground spacer or adapter cover.
8.Lower the cabinet onto the ground spacer or adapter cover and align the mounting holes in the bottom of the cabinet with the holes in the spacer or cover.
9.If the installation includes a ground spacer, secure the cabinet to the spacer using the four hex bolts, four flat washers and four nuts provided with the spacer. If the installation does not include a ground spacer, secure the cabinet to the adapter cover using the four hex bolts, lock flat washers, and four flat washers provided with the cabinet. Tighten all fasteners securely.
10.If the FMS will be used as a splicing vault for the OSP feeder and distribution cables, install the required splice enclosure.
11.Install the FMS sleeve cover onto the FMS and secure using the two capscrews and washers provided with the cover. Tighten both capscrews securely.
3.7.2Mounting TheUse the following procedure to mount the
1.Mount the FMS adapter cover on the FMS and secure using the two capscrews and flat washers provided with the cover as shown in Figure 6. Tighten each capscrew securely.
2.If a ground spacer (accessory) will not be installed, proceed to step 7. If a ground spacer will be installed, align the ends of the left ground spacer section with the ends of the right ground spacer section and then press the two sections together.
3.Place the assembled ground spacer in position for mounting on the adapter cover.
4.Align the mounting holes in the ground spacer with the mounting holes in the adapter cover.
5.Secure the ground spacer to the adapter cover using the four capscrews, four lock washers, and four flat washers provided with the cabinet. Tighten all capscrews securely.
6.Open the rear door of the cabinet and remove the back section of the cabinet bottom cover as described in Section 5.1. Then return to step 7 of this procedure to finish mounting the cabinet.
Page 12
© 2004, ADC Telecommunications, Inc.