ADCP-96-015 • Issue 1 • July 2004
The outside plant (OSP) feeder and distribution cables enter the cabinet from the bottom rear side. Clamps are provided for securing each cable to the inside of the cabinet. The bottom of the cabinet is enclosed with a two-piece removable moisture barrier. The cable entry/exit holes are fitted with grommets to resist the entry of dust and moisture. On an optional basis, the cabinet may be ordered with the distribution cables pre-installed.
The ACE-142S/142V cabinet is constructed of heavy gauge aluminum and is coated with an almond-colored finish. The cabinet doors are equipped with tamper-resistant latches with hasps for padlocks, stainless steel hinges, and door catches to prevent accidental closing. Access to the cabinet requires a 216B key tool (accessory) to operate the latches. Lifting eyes are attached to the sides of the cabinet to allow use of hoisting equipment. A grounding bus is provided within the cabinet for grounding the cabinet and cables per local practice.
The ACE-142S/142V cabinet can accommodate up to thirty-seven round splice trays, up to twelve 1x8 or 1x32 splitter modules, and five 72-position connector panels equipped with APC/ SC adapters. Seven splice tray slots are provided for feeder cable splices. Thirty splice tray slots are provided for distribution cable splices. The ACE-142S/142V cabinet is equipped with two doors that provide front and rear access to the optical components. The specifications for the ACE-142S/142V cabinet are provided in Table 1.
Table 1. ACE-142S/142V Cabinet Specifications
PARAMETER | SPECIFICATION |
Cabinet | |
| |
Dimensions (W x D x H) – See Figure 2 | 27.5 x 19.7 x 47.5 inches (699 x 500.4 x 1206.5 mm) |
| |
Weight (fully loaded) | 210 lbs (95.3 kg) |
| |
Certification (Pending) | GR-2898-CORE (Issue 2, December 1999) |
| |
Distribution ports | 360 (with 5 connector panels installed) |
| |
Distribution port connectors | APC/SC |
| |
Splitter module capacity (1x8 or 1x32) | 12 |
| |
Splice tray capacity (round) | |
Feeder cable | 7 |
Distribution cable | 30 |
| |
Total feeder cable splices | 84 (7 splice trays with 12 splices per tray) |
| |
Total distribution cable splices | 360 (30 splice trays with 12 splices per tray) |
| |
Splitter Modules | |
| |
Splitter module output pigtails | 2 mm with APC/SC connectors |
| |
Splitter module input pigtail | 2 mm |
| |
Test bandpass | 1260–1360 nm |
| 1480–1500 nm |
| 1550–1560 nm |
| |
Overall bandpass | 1260–1625 nm |
| |
Page 2
© 2004, ADC Telecommunications, Inc.
