5 FEEDER CABLE INSTALLATION AND SPLICING
This section describes how to install the OSP feeder cables in the
5.1Bottom Cover Removal
The
1.Open the rear door of the cabinet.
2.Remove the five lock nuts and five flat washers that secure the
3.Lift up the
Note: Be careful not to damage the gaskets that are attached to the underside of the bottom cover. If the distribution cables are
REMOVE BACK SECTION
OF BOTTOM COVER
Figure 12. Bottom Cover
5.2Cabinet Grounding Wire Connection
Prior to mounting the cabinet, a grounding system should have been installed and a grounding wire should have been connected to the grounding system (see Section 3.5 or Section 4.5). Use the following procedure to attached the grounding wire to the cabinet grounding lug:
1.Locate the grounding wire that was installed prior to mounting the cabinet and pull several feet of slack up and into the cabinet.
Page 22
© 2004, ADC Telecommunications, Inc.