6.2Bottom Cover Installation
The
1.Locate the bottom cover
2.Determine which grommets will be used for sealing the cable entry/exit points and remove those grommets from their mounting slots in the bottom cover.
3.Using a utility knife, cut through the slit that runs lengthwise down the center of each grommet as shown in Figure 24.
4.Remove enough cable cutout sections from each grommet to accommodate the size and number of cables that will pass through the grommet.
BOTTOM
COVER
REMOVE CABLE
CUTOUT SECTIONS
CUT SLIT
GROMMET
FEEDER CABLE
GROUNDING
WIRE
DISTRIBUTION
CABLES
DETAIL DRAWIING | |
OF GROMMET |
|
Figure 24. Bottom Cover Installation
5. Install the grommets on the cables.
Note: More than one cable may have to pass though the same grommet.
6. Insert the grommets into their respective mounting slots in the bottom cover.
Page 32
© 2004, ADC Telecommunications, Inc.