
2.Attach the grounding wire to the grounding lug as shown in Figure 13. The grounding lug can be used for #6 – #14 AWG wire. Tighten the grounding lug set screw securely.
3.Leave sufficient slack so the grounding wire can be repositioned as needed when the cable entry section of the bottom cover is
CABINET GROUNDING LUG
(#6 - #14 AWG WIRE)
NOTE: SHOWN WITH BOTH THE FRONT AND REAR SECTIONS OF THE BOTTOM COVER (MOISTURE BARRIER)
REMOVED.
GROUNDING STUDS FOR OSP CABLES WITH METALIC
ELEMENTS
Figure 13. Grounding Wire Connection To Cabinet
5.3Feeder Cable Installation
The OSP feeder cable enters/exits the
Note: If additional splitter modules will be installed in the cabinet as part of the initial installation, complete splitter installation before proceeding with feeder cable installation. Refer to Section 10 for the splitter module installation procedure.
Use the following procedure to install the feeder cable:
1.Route the OSP feeder cable into the cabinet from the bottom. If the cabinet is mounted on a concrete pad, use the duct on the right side.
2.Pull the cable up through the cabinet and strip off 156 inches (396 cm) of the outside cable sheath to expose the fiber subunits.
3.Install
Page 23
© 2004, ADC Telecommunications, Inc.