Addlogix iDP-3410 Drawer Kick-Out Connector And Power Connector, Connectors Pin Configuration

iDP-3410 User’s Manual

11. DRAWER KICK-OUT CONNECTOR AND POWER CONNECTOR

11.1Specifications of Drawer Kick-Out Connector

(1)Drawer kick-out drive signal

Parallel Interface ----- Can be learned at the no. 34 pin of the interface connector

Serial Interface ----- Provided with a command to learn the status in the Star and ESC/POS

modes.

(2)Electrical characteristics

1)Drive voltage: 24 V DC

2)Drive current: 0.8 A at maximum(Within 510 ms)

3) Switch signal: Signal level	"L"	= 0	∼ 0.5 V
	"H"	= 3	∼ 5 V

11.2 Connector's Pin Configuration

No.

Signal

Function

1	FG	Frame Ground
2	DRAWER 1	Drawer 1 drive signal
3	DRSW	Drawer switch input
4	VDR	Drawer drive power
5	DRAWER 2	Drawer 2 drive signal
6	GND	Common ground on the circuit

Connector used		: TM5RJ3-66 (HIROSE)
Applicable connector		: TM3P-66P (HIROSE) or equivalent
CAUTION : ∙	No output is made while printing.
∙	The drawers 1 and 2 cannot be driven simultaneously.

∙A solenoid used for the drawer should be of 36Ω or more. An output current should be kept below 0.8 A. Use beyond this limit cannot be assured.

∙This connector cannot be connected to a telephone line. Do not connect other than the solenoid.

11.3 Drive Circuit