Agilent Technologies 5742A, 5752A manual Connecting the Line Cord, Input Connections for 750W units

Installation 2

Connecting the Line Cord

	SHOCK HAZARD The power cord provides a chassis ground through a third
WARNING
	conductor. Be certain that your power outlet is of the three-conductor type
	with the correct pin connected to earth ground.
	FIRE HAZARD Use only the power cord that was supplied with your
	instrument. Using other types of power cords may cause overheating of the
	power cord, resulting in fire.

	The detachable power cord may be used as an emergency disconnecting
NOTE
	device. Removing the power cord will disconnect ac input power to the unit.

The AC input on the back of your unit is a universal AC input. It accepts line voltages in the range of 85 VAC to 265 VAC. The frequency range is 47 Hz to 63 Hz.

The input current requirement of 750W units is 10.5A @ 100 VAC nominal and 5A @ 200 VAC nominal. The current requirement of 1500W units is 21A @ 100 VAC nominal and 11A @ 200 VAC nominal.

Input Connections for 750W units

Connect the power cord to the IEC 320 connector on the rear of the unit. The IEC connector provides the safety ground connection when the AC cord is plugged into a grounded AC receptacle.

If the wrong power cord was shipped with your unit, contact your nearest Agilent Sales and Service Office.

Input Connections for 1500W units

	Connection of this power supply to an AC power source should be made by a
CAUTION
	qualified electrician or other qualified personnel.

The AC input connector is a 3-terminal wire clamp located on the rear panel. Use suitable wires and tightening torque as follows:

•Wire diameter: 12 AWG or 10 AWG

•Tightening torque: 6.5 - 7.0 in-lb

Connect the cable to the AC input connector as follows:

•Strip the outside insulation of the AC cable approximately 10 cm (4 in). Trim the wires so that the ground wire is 10 mm (0.4 in) longer than the other wires. Strip 14 mm (0.55 in) at the end of each of the wires.

Series N5700 User’s Guide 19