Aiphone IS-SOFT Calling another station direct voice call, Click To start calling talking

Calling another station (direct voice call)

Follow the steps below to call a desired door station, room sub station or master station in your site, or remote site.

1 Search for and select the station or remote site you want to call (so that it is highlighted) in one of the search methods. (→P. 21-24)

*If you call (the pilot station in) a remote site by searching for it from [REMOTE SITE] of SEARCH LIST, select the target site, and then select [CALL] (so that it is highlighted). (→P. 23)

Refer to the on-screen instructions:

Be sure to make operations by checking the information on the upper part of the list area. The next operations you can perform are displayed.

e.g.)

[ ] TALK … You can start talking by clicking .

*If you will not set the priority, it is set to “Normal”.

[] MONI … You can start monitoring by clicking . [ ] PR (or PRIORITY)

………You can proceed to the priority setting mode by clicking .

2 To set the priority, click , and then click to

select the target priority (so that it is highlighted).

*If you will not set the priority, skip this step and click

. You can start calling (talking) with “Normal” priority.

3 Click or to start calling (talking).

or

When a tone rings, your voice is heard at the target station and you can also hear sounds at the target station. (Direct voice call)

The receiver can answer the call without pressing any button or lifting the handset. (Talk back)

*If the target station is a (PC) master station, the response of it differs from the PRIVACY mode setting on the target station. (See the table below.)

PRIVACY mode
setting on the target	Response
master station
	Your voice is heard at the target
OFF	station and you can also hear sounds
	at the target station.
	Communication is enabled when
1	the receiver makes an answering
	operation. Otherwise you can hear no
	sound from the target station.
	When the target station receives your
	call, a tone notifies you that the target
	station is in the “Privacy 2” mode.
	Communication is enabled when
	the receiver makes an answering
2	operation. Otherwise you can hear no
	sound from the target station.
	* You can adjust the volume of call
	tone by using the speaker volume
	adjusting slider in the volume
	control window.

4 Click to finish communicating.

GETTING STARTED USING THE PC MASTER STATIONAPPENDIX

25