Airlink CDMA/1x manual Basic Commands common AT commands, None

Basic Commands

These commands are common to most communication devices using AT Com- mands.

TABLE 3. Basic Commands (common AT commands)

Command	Parameters	Details
+++	none	AT Escape sequence.
The "+" is ASCII 0x2B.		Not proceeded by AT.
		If the Raven is in a data mode (any mode other than
		PassThru), this command causes the modem to re-enter
		AT command mode.
		There must be an idle time (set by S50) on the serial port
		before and after this command.
		The detection of +++ is disabled if DAE=1.
A/	none	Re-execute last command.
		Not proceeded by AT.
A	none	Answer - manual
DAE=n	n=0 or 1	Disable AT Escape Sequence detection.
		0 : Enable +++ AT escape sequence detection.
		1 : Disable +++ AT escape sequence detection.
En	n=0 or 1	Toggle AT command echo mode.
		0 : Echo Off
		1 : Echo On
Hn	n=1	Hang-Up Command.
		1: Hang-up
		Note: With an AT telnet connection, this command will
		terminate the host data mode and return the Raven to an
		AT mode.
O	none	Online (Remote): Causes the Raven to go from Com-
		mand State to data state.

Raven CDMA User Guide for Verizon, version 2.23 61