TABLE 6. Local Network and Host Modes

Command

Parameters

Details

 

 

 

*UDPLAST=n

n=0 or 1

If enabled, sets S53 to the last accepted IP address

 

 

through UDP auto answer. This can be used in conjunc-

 

 

tion with MD3 so that when there is no UDP session,

 

 

new ethernet host data will cause a connection to be

 

 

restored to the last IP accepted through UDP auto

 

 

answer. .

 

 

0 : Does not change S53 setting. (Default).

 

 

1 : Set S53 to the last accepted IP.

 

 

Note: This does not change the S53 setting in NVRAM.

 

 

If the modem is reset, the original S53 setting will be

 

 

restored from NVRAM.

 

 

 

*USD=n

n=1-255

Waits the specified delay before sending the first UDP

 

 

packet and the subsequent UDP packets out to the serial

 

 

port.

 

 

0 : No UDP packet delay (Default).

 

 

Delay in 100ms units, from 100 ms to 25.5 sec.

 

 

 

\Qn

n=0 2 4

Set or query the serial port flow control setting.

 

 

0 : No flow control is being used.

 

 

1 : RTS/CTS hardware flow control is being used.

 

 

4: Transparent software flow control. Uses escaped

 

 

XON and XOFF for flow control. XON and XOFF char-

 

 

acters in data stream are escaped with the @ character

 

 

(0x40). @ in data is sent as @@.

 

 

 

\APPP

none

Set modem operation to PPP mode.

 

 

 

\ASLIP

none

Set modem operation to SLIP mode. DTR must be

 

 

asserted (&D0 or S211=1).

 

 

 

Caution: Not all AT Commands can be used while in PassThru mode.

Direct Communication

Direct Communication can be used with the Raven to contact other Internet devices to pass information or other tasks.

72

Raven CDMA User Guide for Verizon, version 2.23

Page 78
Image 78
Airlink CDMA/1x manual Direct Communication