Airlink CDMA/1x Modbus Settings, Cannot be configured in Wireless ACE, MLISTid=d.d.d.d, D.d=IP or

TABLE 16. Modbus Settings

Command	Parameters	Details
IPL=n	n=0 or 1	IP List Dial
		This allows access the Modbus IP list using the first two
		digits of the dial string. Example: ATDT1234567 would
		go to ID "12" on the Modbus list and use the associated
		IP as the destination.
		0 : Disabled
		1 : Enabled
		Cannot be configured in Wireless ACE.
MDhh	hh (hex byte) =	Default power-up mode.
	00 - normal	When the PinPoint is power-cycled, it may enter the
	mode	mode specified by this command after 5 seconds. On
	01 - SLIP mode	startup, typing ATMD0 within 5 seconds changes the
		mode to normal (AT command) mode.
	02 - PPP mode
		See also S53 to set the port for UDP or TCP.
	03 - UDP mode
	04 - TCP mode
	07 - PassThru
	mode
MLISTid=d.d.d.d	id=ID	Enters an ID and IP address into the Modbus List. ID is
	d.d.d.d=IP or	a decimal value (1 to 100).
	name adresse	Note: In Wireless ACE, this command (and MLISTX) is
		the Addr List menu option.
MLISTXhexid=d.d.d.d	hexid=ID	Enters an ID and IP address into the Modbus List. ID is a
	d.d.d.d=IP or	hexadecimal value (0 to 64).
	name adresse	Note: This value is entered via Wireless ACE as 0xHex.
MVLEN=n	n= 1 or 2	Modbus Variant ID Length.
		Length of the RTU ID in a modbus-variant protocol, in
		bytes. This parameter is used to define the length of the
		RTU ID in Modbus-like protocol data packets. This
		parameter is used when the when the MD is set to hex
		63.
		Cannot be configured in Wireless ACE.

Raven CDMA User Guide for Verizon, version 2.23 83