TABLE 6. Local Network and Host Modes

Command

Parameters

Details

 

 

 

+++

none

AT Escape sequence.

 

 

If the Raven is in a data mode (any mode other than

The "+" is ASCII 0x2B.

 

PassThru), this command causes the modem to re-enter

 

AT command mode.

This command is not pro-

 

 

Note: There must be an idle time (set by S50) on the

ceeded by AT.

 

 

serial port before and after this command. The detection

 

 

 

 

of +++ is disabled if DAE=1.

 

 

 

AIP=n

n=0

Allow only the IP specified in S53 to connect when UDP

 

 

auto answer is enabled (S82=2).

 

 

Allow any incoming IP to connect when UDP auto

 

n=1

answer is enabled (S82=2).

 

Always subject to any Friends filters that may be

 

 

 

 

defined.

 

 

 

HOR=n

 

Half-Open Response - In UDP auto answer (half-open)

 

 

mode:

 

n=0

No response codes when UDP session is initiated.

 

RING CONNECT response codes sent out serial link

 

 

 

n=1

before the data from the first UDP packet.

 

 

Note: Quiet Mode must be Off.

 

 

 

MDhh

hh (hex byte) =

Default power-up mode.

 

00 - normal

When the PinPoint is power-cycled, it may enter the

 

mode

mode specified by this command after 5 seconds. On

 

01 - SLIP mode

startup, typing ATMD0 within 5 seconds changes the

 

mode to normal (AT command) mode.

 

02 - PPP mode

 

See also S53 to set the port for UDP or TCP.

 

03 - UDP mode

 

 

 

04 - TCP mode

 

 

07 - PassThru

 

 

mode

 

 

 

 

66

Raven CDMA User Guide for Verizon, version 2.23

Page 72
Image 72
Airlink CDMA/1x manual Local Network and Host Modes, This command is not pro Ceeded by AT