Airlink CDMA/1x manual Direct Communication

TABLE 8. Direct Communication

Command	Parameters	Details
D[method][d.d.d.d][/ppppp]	method = P, T, N	Dial a connection to a remote IP and Port using method.
or	d.d.d.d = IP	P - Establish a UDP connection
D[method][@name][/ppppp]	address to con-	T - Establish a TCP connection
	tact	N - Establish a Telnet connection
	name = domain
		ATD - Dial (establish) default connection.
	name to contact
		ATDP192.168.13.31/2332 - Dial (establish) UDP ses-
	ppppp = IP port
		sion to 192.168.13.31, at port 2332.
	to contact
		To end the connection, issue the +++ escape sequence or
		drop the DTR line (if Ignore DTR S211=0 or &D2).
D continued	see above	The defualt connetion is set in S53.
		If a domain name is specified, the '@' symbol can be
		used to explicitly indicate the start of the name. For
		example, if ATDPHONY is issued, this will be inter-
		preted as dial a UDP connection to "HONY". To dial
		using the default method to host "PHONY", one would
		issue ATD@PHONY. .
		If the method, IP address, or port is omitted, the values
		from S53 are used. If a telnet connection is requested (N)
		and the port is not supplied, port 23 will be used instead
		of the value from S53.
		Several special dialing numbers exist to make it easy to
		establish a PPP or SLIP connection with the modem.
		ATD#19788 or ATDT#19788 will establish a PPP con-
		nection (see \APPP) and ATDT#7547 will establish a
		SLIP connection (see \ASLIP).
		Note: The source port of the session is the Device Port
		(set by S110 or *DPORT).
PINGd.d.d.d[,n]	d.d.d.d = IP	Ping the specified IP address.
or	address to con-	Sends a single ping, returns either OK or ERROR
	tact
PING domain_name[,n]		depending on result. Times out in 10 seconds. If n is pro-
	n = amount of
		vided, it specifies the amount of data to send with the
	data to send	ping. If n is not provided, the default, 50 bytes is used.

74 Raven CDMA User Guide for Verizon, version 2.23