Aiwa XR-MR5 manual Unfinalization

4Within 10 seconds, press ENTER/ILLUMINATION.

Alternatively, press ENTER on the remote control. If you erase the track, you cannot retrieve it again. Make sure it is all right to erase the track.

To cancel, press s.

5Within 1 minute, press ENTER/ILLUMINATION

again.

Alternatively, press ENTER on the remote control.

"ERASE" appears on the display, the approximate erasing time is displayed and counts down.

NOTE

You cannot erase any track other than the last track directly. For example, if you want to erase the 11th track on a 12-track CD- RW, you have to erase the last (12th) track first, and then erase the target (11th) track.

You cannot erase the 11th track without erasing the 12th track.

UNFINALIZATION

Unfinalization is the process of erasing a Table Of Contents (TOC) on a CD-RW and is applicable only to a finalized CD-RW. Unlike all tracks erasing or last track erasing, unfinalization does not erase any tracks on a CD-RW. The tracks will be kept intact. This process enables a CD-RW to be recorded on again if there is enough recordable space.

Unfinalized CD-RW discs, however, cannot be played on the CD player of this unit or any other conventional CD players.

To do so, finalize the CD-RW.

NOTE

•Never turn the unit off by pressing POWER or disconnecting the AC cord during the unfinalizing process.

If the unit is turned off even by accident or power failure damages the disc and it may no longer be restored.

•A CD-R cannot be unfinalized.

•Do not unfinalize the CD-RW which was finalized on other equipment. Doing so may cause the unfinalizing process to be unsuccessful.

•During the unfinalizing process, all the buttons (except POWER) are inoperative.

•Dust or scratches on a disc may prevent it from being successfully unfinalized.

ENTER/	RECORDINGERASING AONCD-RW
UNFINALIZING A CD-RW
s	CD-R/RW
ERASE MODE
ILLUMINATION
CD-R/RW	s
	ENTER
zCD-R/RW	ERASE MODE
OPEN/CLOSE

1Load a CD-RW in the CD-R/CD-RW player/recorder.

Load the disc with the label side up. To open or close the disc tray, press z CD-R/RW OPEN/CLOSE.

2Press CD-R/RW.

Wait until the unit finishes reading the loaded disc. (Make sure

the "CD-RW" indicator lights up.)

3In stop mode, press ERASE MODE repeatedly until "UNFINAL ?" is displayed.

En

4Within 10 seconds, press ENTER/ILLUMINATION.

Alternatively, press ENTER on the remote control. "UNFINAL??" is displayed.

To cancel, press s.

5Within 1 minute, press ENTER/ILLUMINATION again.

Alternatively, press ENTER on the remote control.

The approximate unfinalizing time is displayed and counts down.

ENGLISH 25