Aiwa XR-MR5 Recording from the Radio or the Connected Equipment, Select the source to be recroded

RECORDING FROM THE RADIO OR THE CONNECTED EQUIPMENT

	AUX/D-IN
s	TUNER
	ENTER
a
REC
ENTER/
ILLUMINATION
TUNER	s
AUX/D-IN	a
zCD-R/RW	wREC
OPEN/CLOSE

1Load a CD-R or CD-RW in the CD-R/CD-RW player/

recorder.

Load the disc with the label side up. To open or close the disc tray, press z CD-R/RW OPEN/CLOSE.

Wait until the unit finishes reading the loaded disc. (Make sure the "CD-R" or "CD-RW" indicator lights up.)

2Select the source to be recroded.

•To record from the radio, press TUNER and tune in to a station.

•To record from the equipment connected to the DIGITAL IN jack on the rear, press AUX/D-INrepeatedly until "D-IN" appears on the display.

•To record from the equipment connected to the AUX/VIDEO IN jacks on the rear, press AUX/D-INrepeatedly until "AUX" appears on the display.

3Press REC on the main unit or wREC on the remote

control.

The unit enters the standby mode. Wait until the source name selected at step 2 is displayed.

4When recording from the radio, press a to start recording.

When recording from the connected equipment, press a to start recording, and start playback of the connected equipment.

To stop recording

Press s.

When recording finishes, "CD-R/RW REC" indicator disappears in the display.

To pause recording

Press a. To resume recording, press a again.

To record on a previously recorded CD-R or CD-RW

If there is an unrecorded section left on the CD-R or CD-RW, the new recording automatically starts from where the previous recording finished. If you want to start recording from the beginning of a previously recorded CD-RW, erase the previous recording completely. (See page 24.)

Afinalized* CD-R or a finalized CD-RW, however, cannot be recorded on.

* See "FINALIZATION" on page 23.

To add track marks during recording

Press ENTER/ILLUMINATION on the main unit or ENTER on the remote control at the desired point during recording.

Note, however, that once a track mark is registered, the next track mark cannot be added for 4 seconds.

NOTE

•When a track mark is registered, the track number on the CD-R or CD-RW is increased by one.

•If you pause recording, the track number increases.

•Depending on the source, there is a case where the very beginning portion of the sound is cut off from the recording.

•When recording from equipment connected to the AUX/VIDEO IN jacks, recording automatically stops:

-if there is a blank section lasting more than 10 seconds in the input signal.

-if 1 minute has elapsed after the recording pause mode was entered.

22 ENGLISH