Aiwa Z-VR55 manual 5 +,H m, Press PRGM in stop mode, Press RANDOM on the remote control

m

●When Ioadina an 8-cm f3-inch) disc, make sure to Dlace it onto the inner circle of the trav precisely. Otherwise, the disc may be damaged or the disc compartment will not open. If it does not open, please consult your Aiwa dealer for repair.

●Do not place more than one compact disc on one disc tray.

●Do not tilt the unit with discs loaded. Doing so may cause malfunctions.

●When transporting the unit, remove the discs from the trays.

●When replacing the discs during play, do not replace discs other than those facing you.

If you place a disc on the empty right inner tray, and then press A OPEN/CLOSE, “ERROR” is displayed and the disc compartment may not close. Remove the disc on that tray.

Press RANDOM on the remote control.

“RANDOM”lights up on the display.

To cancel random play, press again.

To ~lav all discs, press - to start play.

To dav a sinale disc, press one of DISC DIRECT PLAY 1-5 to start play.

During random play, it is not possible to skip to the previously played track with +.

A single disc or all the discs can be played repeatedly.

Press REPEAT on the remote control.

“G” lights up on the display.

To plav all discs, press *to start play.

To dav a sinale disc, press one of DISC DIRECT PLAY 1-5 to start play.

/

upto 30 tracks can be programmed from any of the inserted discs.

1

2

3

5 +,H

m

Use the remote control.

1 Press PRGM in stop mode.

“PRG”is displayed .

2 Press DIRECT, then press one of the numbered buttons 1 to 5 within 3 seconds to select a disc.

Go to the next step when the tray stops rotating.

3Press numbered buttons O-9 and +10 to program a track.

Example:

To select the 25th track, press +10, +10 and 5. To select the 10th track, press +1O and O.

Selected track number	Total number of selected tracks
	I

I

Program numberTotal playing time of the selected tracks

4Repeat steps 2 and 3 to program other tracks.

5Press -to start play.

To check the program

Each time + or - is pressed in stop mode, a disc number, track number, and program number will be displayed.

To clear the program

Press ■CLEAR in stop mode.

To add tracks to the program

Repeat steps 2 and 3 in stop mode. The track will be programmed after the last track.

To change the programmed tracks

Clear the program and repeat all the steps again

During programmed play, you can not use random play, check the remaining time or select a disc or track.

1 I ENGLISH